EasyManua.ls Logo

Craftsman 580.767200 - User Manual

Craftsman 580.767200
44 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
5.5 HORSEPOWER
2,250 PSI
2.2 GPM
PRESSURE WASHER
CUSTOMER HELPLINE
1-800-222-3136
Model No. 580.767200
CAUTION:
Before using this product,
read this manual and follow all Safety
Rules and Operating Instructions.
HOURS: Mon. - Fri. 8 a.m. to 5 p.m. (CT)
Part No. 187687 Draft 3 (08/09/2001)
SEARS, ROEBUCK and CO., Hoffman Estates, IL 60179 U.S.A.
Visit our Craftsman website: www.sears.com/craftsman
Owner’s Manual
• Safety
• Assembly
• Operation
• Maintenance
• Parts
• Español

Table of Contents

Questions and Answers

  • K
    Katrina AdamsJul 31, 2025
    Why does my Craftsman 580.767200 have low pressure?
    • C
      Catherine HughesJul 31, 2025
      There are several reasons why your Craftsman Pressure Washer might have low pressure. It could be due to the nozzle being in low pressure mode—try pulling it backward for high pressure. Other potential causes include a blocked water inlet (clear it), an inadequate water supply (provide adequate flow), a kinked or leaking inlet hose (straighten or patch it), a clogged inlet hose strainer (check and clean it), water supply being too hot (use cooler water), a blocked or leaking high pressure hose (clear any blockages), a leaking gun (replace it), or an obstructed nozzle (clean it). If none of these steps work, the pump may be faulty, and you should contact Sears service facility.
  • H
    Heather LopezAug 8, 2025
    What to do if my Craftsman Pressure Washer won't start?
    • S
      Stephen RileyAug 8, 2025
      If your Craftsman Pressure Washer won't start or runs rough, several factors could be the cause. Check the following: * Ensure the oil level is adequate by filling the crankcase to the proper level. * Clean or replace the air cleaner if it's dirty. * Make sure you have gasoline in the tank, and if the gasoline is stale, drain the tank and fill it with fresh fuel. * Confirm the spark plug wire is connected to the spark plug, and replace the spark plug if it's bad. * Also, drain the gas tank and fill it with fresh fuel if there is water in the gasoline. If the engine is overchoking, open the choke fully and crank the engine. For excessively rich fuel mixture, intake valve issues, or lost compression, contact Sears service facility.
  • R
    Richard MartinezAug 14, 2025
    Why does my Craftsman 580.767200 engine shut down while running?
    • M
      Meredith BrewerAug 15, 2025
      If your Craftsman Pressure Washer engine shuts down during operation, the most likely reason is that it is out of gasoline. Refill the fuel tank.
  • J
    Jennifer LewisAug 22, 2025
    How to fix detergent not mixing in my Craftsman Pressure Washer?
    • C
      christina42Aug 22, 2025
      If the detergent is not mixing with the spray in your Craftsman Pressure Washer, make sure the detergent siphoning tube is fully submerged in the detergent. Also, check the chemical filter and clean or replace it if it's clogged. Ensure the nozzle is in low pressure mode by pushing it forward. For dirty in-line filter, see “Check In-Line Filter” on page 10.

Summary

Warranty

Safety Rules

Assembly

Operation

Maintenance

Pressure Washer Maintenance

Details maintenance tasks for the pressure washer unit itself, including screens and hoses.

Engine Maintenance

Covers checking and changing engine oil, and servicing the air cleaner.

Storage

Winter Storage

Instructions for protecting the unit from freezing temperatures during storage.

Long Term Storage

Procedures for preparing the engine and pump for storage longer than 30 days.

Troubleshooting

Parts

Emission Control Warranty Statement

Craftsman 580.767200 Specifications

General IconGeneral
Power SourceGasoline
Flow Rate2.3 GPM
Hose Length25 feet
Nozzle Types4 Quick-Connect Nozzles
Water Flow2.3 GPM
Pump TypeAxial Cam
Nozzle IncludedYes
Soap ApplicatorYes
Wheel Size10 in

Related product manuals