Craftsman 675 Series User Manual (English)

Other manuals for Craftsman 675 Series

Questions and Answers:

K
Keith SchneiderAug 17, 2025
Why my Craftsman Lawn Mower does not start?
- A
  Austin DominguezAug 18, 2025
  Your Craftsman Lawn Mower might not start due to several reasons: * A dirty air filter. Clean or replace it. * Lack of fuel. Refill the fuel tank. * Stale or water-contaminated fuel. Empty and refill with fresh, clean gasoline. * A disconnected spark plug wire. Reconnect the wire. * A bad spark plug. Replace the spark plug. * A loose or broken blade adapter. Tighten the blade bolt or replace the adapter. * The control bar is not depressed. Depress the control bar to the handle. * A defective control bar. Replace it. * The fuel valve lever is in the OFF position. Turn it to ON. * A weak battery (if equipped). Charge the battery. * A disconnected battery connector (if equipped). Connect the battery to the engine.
A
Ashley HuntAug 20, 2025
How to fix Craftsman 675 engine that fails to start?
- A
  Adrian GomezAug 20, 2025
  There are several possible reasons why your Craftsman Log Splitter engine might fail to start: * The spark plug wire may be disconnected. Connect it to the spark plug. * The fuel tank may be empty or contain stale fuel. Fill the tank with clean, fresh gasoline. * The choke lever may not be in the CHOKE position. Move the choke to the CHOKE position. * The spark plug may be faulty. Service the spark plug following the maintenance instructions. * The fuel line may be blocked. Clean the fuel line. * The air cleaner may be dirty. Service the air cleaner following the maintenance instructions.
P
Phillip JonesAug 23, 2025
Why is my Craftsman Lawn Mower losing power?
- J
  Joyce RamirezAug 23, 2025
  If your Craftsman Lawn Mower is losing power, consider these potential causes: * The rear of the mower housing or blade may be dragging in heavy grass. Try raising the cutting height. * You might be cutting too much grass at once. Increase the cutting height. * The air filter could be dirty. Clean or replace it. * There might be a buildup of grass, leaves, and trash under the mower. Clean the underside of the mower housing. * There may be too much oil in the engine. Check the oil level. * Your walking speed could be too fast. Cut at a slower pace.
R
Ryan KimAug 26, 2025
How to fix poor uneven cut from Craftsman Lawn Mower?
- G
  Glen MirandaAug 26, 2025
  An uneven cut with your Craftsman Lawn Mower can be caused by: * A worn, bent, or loose blade. Replace the blade and tighten the blade bolt. * Uneven wheel heights. Set all wheels at the same height. * Buildup of grass, leaves, and trash under the mower. Clean the underside of the mower housing.
W
wigginsedwardAug 28, 2025
Why is the starter rope hard to pull on my Craftsman Lawn Mower?
- N
  nmoyerAug 28, 2025
  If the starter rope on your Craftsman Lawn Mower is hard to pull, it could be due to: * The engine flywheel brake being engaged when the control bar is released. Depress the control bar to the upper handle before pulling the starter rope. * A bent engine crankshaft. * A broken blade adapter. Replace the blade adapter. * The blade dragging in grass. Move the lawn mower to cut grass or to a hard surface.
H
Hannah HawkinsAug 30, 2025
Why is my Craftsman Lawn Mower so hard to push?
- L
  Lawrence ScottAug 30, 2025
  If your Craftsman Lawn Mower is hard to push, consider the following: * The grass may be too high, or the wheel height may be too low. Raise the cutting height. * The rear of the mower housing or cutting blade might be dragging in the grass. Raise the rear of the mower housing one setting higher. * The grass catcher could be too full. Empty the grass catcher. * The handle height position might not be right for you. Adjust the handle height to suit your comfort.
T
Tony HillSep 1, 2025
What to do if Craftsman Lawn Mower losing drive?
- M
  mharringtonSep 1, 2025
  If your Craftsman Lawn Mower is experiencing a loss of drive or slowing drive speed, check for: * Belt wear. Check or replace the drive belt. * The belt being off the pulley. Check and reinstall the drive belt. * A worn or broken drive cable. Replace the drive cable. * A loose drive control system. Adjust the drive control.
P
Pamela CalhounSep 4, 2025
Why is my Craftsman Lawn Mower vibrating so much?
- M
  michael48Sep 4, 2025
  Excessive vibration in your Craftsman Lawn Mower may be due to: * A worn, bent, or loose blade. Replace the blade and tighten the blade bolt. * A bent engine crankshaft.
E
Elizabeth FergusonSep 6, 2025
What to do if grass catcher not filling on Craftsman Lawn Mower?
- M
  Melanie CaseSep 6, 2025
  If the grass catcher on your Craftsman Lawn Mower is not filling, it could be due to: * The cutting height being too low. Raise the cutting height. * The lift on the blade being worn off. Replace the blade. * The catcher not venting air. Clean the grass catcher.
I
icarlsonSep 9, 2025
Why is my Craftsman Log Splitter engine running erratically?
- D
  danielstewartSep 9, 2025
  If your Craftsman Log Splitter engine is running erratically with inconsistent RPM, it could be due to: * The unit running with the CHOKE applied. Move the choke lever to the RUN position. * A loose spark plug wire. Connect and tighten the spark plug wire. * A blocked fuel line or stale fuel. Clean the fuel line and fill the tank with clean, fresh gasoline (less than 30 days old). * Water or dirt in the fuel system. Drain the fuel tank and refill with fresh fuel. * A dirty air cleaner. Clean or replace the air cleaner. * The carburetor is not adjusted properly. Contact Sears service center.