9
Clamp size Opening 0.9" (23mm) approx.
Diode Test Open circuit voltage <1.5V DC;
Test current 0.3mA (typical)
Continuity Check Audible signal <150;
Test current < 1mA
Temperature sensor Type K thermocouple
Input Impedance 7.8M (VDC and VAC)
Display 3-3/4 digits (4000 counts) LCD
AC V bandwidth 50Hz to 400Hz
AC A bandwidth 50/60Hz
AC response Averaging
Operating Temperature 41 to 104
o
F (5 to 40
o
C)
Storage Temperature -4 to 140
o
F (-20 to 60
o
C)
Operating Humidity Max 80% up to 87ºF (31ºC) decreasing
linearly to 50% at 113ºF (45ºC)
Storage Humidity <80%
Operating Altitude 6560 ft. (2000 meters) maximum
Over voltage Category III 600V
Battery (2) 1.5V AAA Batteries
Auto OFF After 30 minutes of continuous use
Dimensions/Weight 7.87x1.97x1.38" (200x50x35mm) 0.44
lbs. (200g)
Safety This meter is intended for indoor use
and protected, against the users, by
double insulation per EN61010-1 and
IEC61010-1 2nd Edition (2001) to CAT
III 600V; Pollution Degree 2. The meter
also meets UL 61010-1, Second Edition
(2004), CAN/CSA C22.2 No. 61010-1,
Second Edition (2004), and UL 61010B-
2-031, First Edition (2003)
To Next Page
Loading...
