HOW TO SET UP YOUR TRACTOR
CHECK BATTERY
• Liftseat pan toraisedpos_dionandopen
battelyboxdoor.
• It thisbatteryis put into se_ice after
monthandyear indicatedonlabel (label
iocated between termi_ls) chargebat-
teryforminimumofonehourat 6-10
amps.(See "BA'I-rERY=in MAINTE-
NANCE sectionof thismanual for
charginginstructions).
Seat Pan
Label
Battery
Be
INSTALL SEAT
Adjust seat before tightening adjustment
knob.
• Remove cardboard packing on seat
pan,
• Place seat on seat pan and assemble
shoulder boll -Rghten shoulder bolt
securely.
• Assemble adjustment knob and flat
washer loosely. Do not tighten.
• Lower seat into operating position and
sit on seat.
• slide seat un_l a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down.
• Get off seat without moving its adjusted
,position.
• R_,_e seat and tighten adjustment knob
securely.
- Seat
Seat Pan
Shoulder
Belt
INSTALL MULCHER PI.ATE
• instafltwo latch boolw tomusher plata
using screw,washer,lockwasher,and
weld nutas shown.
NOTE: pre-aasembleweld nutto latch
hookby insertingweldnutfromthe top
withhookpointingdown.
• Tightenhardwaresecurely.
• Raiseandholddeflectorshieldinup-
rightpos'_on.
• Placefrontof muicherplateoverfrontof
mowerdeckopeni_Jandslideinto
place,as shown.
• Hookfrontlatchintoholeonfrontof
mowerdeck.
• Hookrear latch intoholeon backof
mowerdeck.
,_CAUTION: De notremovedischarge
guardfrom mower.Raiseand holdguard
whenattachingmuicherplate andallow it
toreston platewhilein operation.
Weld Nut From Hoot( Points
The Top _o'_
Lock [_J
Weld Washer _ "_
Nut'x_ Screw _X_ tch
D\\ \weld.ut
Washer
M_cher '_ Screw
Plate
Deflector __
Shield
Adjustment Knob
Washer
To Next Page