Craftsman 944.367412 - User Manual

Questions and Answers

F
fhallAug 2, 2025
Why my Craftsman 944.367412 does not start?
- E
  Edward ReidAug 2, 2025
  If your Craftsman Lawn Mower doesn't start, several factors could be at play. Ensure the control bar is depressed to the handle and the fuel valve lever is in the ON position. Check for a disconnected spark plug wire and connect it. A dirty air filter needs cleaning or replacement. The fuel tank might be empty, require fresh fuel due to staleness or water contamination, or the spark plug may be bad, necessitating replacement. Also, a loose blade or broken blade adapter should be tightened or replaced, respectively. For models with a battery, ensure it's charged and properly connected. If the control bar is defective, it should be replaced.
K
Kathleen DuncanAug 7, 2025
Why is my Craftsman 944.367412 losing power?
- D
  Dawn ThomasAug 7, 2025
  Loss of power in your Craftsman Lawn Mower can occur for several reasons. Check if the rear of the mower housing or blade is dragging in the grass and raise the cutting height if needed. Avoid cutting too much grass at once by also raising the cutting height. Ensure the air filter is clean, cleaning or replacing it if dirty. Remove any buildup of grass, leaves, or trash from under the mower. Verify that the engine oil level is correct, and reduce your walking speed while cutting.
S
scastilloAug 11, 2025
Why is the starter rope hard to pull on my Craftsman Lawn Mower?
- J
  Jesus SmithAug 11, 2025
  If your Craftsman Lawn Mower's starter rope is hard to pull, it could be due to several reasons. Make sure to depress the control bar to the upper handle before pulling the starter rope. Check if the blade is dragging in the grass and move the mower to a cleared area. If the blade adapter is broken, replace it. For bent engine crankshaft, contact a Sears or other qualified service center.
T
turneradamAug 16, 2025
How to fix poor and uneven cut of Craftsman 944.367412 Lawn Mower?
- R
  Rachel MartinAug 16, 2025
  Uneven cutting with your Craftsman Lawn Mower can be attributed to a worn, bent, or loose blade, which should be replaced or tightened. Ensure all wheel heights are set evenly. Also, clear any buildup of grass, leaves, and trash from underneath the mower housing.
P
Patricia McculloughAug 19, 2025
What to do if my Craftsman 944.367412 has excessive vibration?
- Z
  Zachary JordanAug 19, 2025
  Excessive vibration in your Craftsman Lawn Mower can stem from a worn, bent, or loose blade; replace the blade and tighten the blade bolt. For a bent engine crankshaft, contact a Sears or other qualified service center.
J
Jacob FordAug 25, 2025
Why is my Craftsman 944.367412 Lawn Mower hard to push?
- G
  gguerreroAug 25, 2025
  If your Craftsman Lawn Mower is hard to push, it could be due to grass that is too high, or a wheel height that is too low; raise the cutting height. If the rear of the mower housing or blade is dragging in grass, raise the rear of the mower housing one setting higher. Empty the grass catcher if it is too full and adjust the handle height to suit your comfort.
C
Cassandra WilliamsAug 28, 2025
What to do if grass catcher is not filling on Craftsman 944.367412 Lawn Mower?
- M
  Matthew SandersAug 28, 2025
  If the grass catcher on your Craftsman Lawn Mower isn't filling, try raising the cutting height. A worn blade lift should be addressed by replacing the blade. Also, ensure the grass catcher is venting air properly by cleaning it.

Summary

WARRANTY

COMMERCIAL OR RENTAL USE

Details warranty coverage for commercial or rental use.

This Warranty does NOT cover

Lists exclusions from the product warranty.

SAFETY RULES

I. GENERAL OPERATION

Guidelines for safe operation and user familiarity with controls.

II. SLOPE OPERATION

Guidelines for safe mowing on inclines and slopes.

III. CHILDREN

Warnings and precautions regarding children near the mower.

IV. SAFE HANDLING OF GASOLINE

Precautions for safe storage and use of gasoline.

V. GENERAL SERVICE

General maintenance and safety practices for the lawn mower.

PRODUCT SPECIFICATIONS

ASSEMBLY; PRE-OPERATION

TO REMOVE MOWER FROM CARTON

Steps to unpack and remove the lawn mower from its carton.

HOW TO SET UP YOUR MOWER

Instructions for unfolding and setting up the mower handle.

OPERATION

KNOW YOUR LAWN MOWER

Familiarization with mower controls, adjustments, and symbols.

MEETS CPSC SAFETY REQUIREMENTS

Conformance to safety standards and blade operation.

HOW TO USE YOUR LAWN MOWER

Guidance on operating the lawn mower.

SIMPLE STEPS TO REMEMBER WHEN CONVERTING YOUR LAWN MOWER

FOR MULCHING

Steps for setting up the mower for mulching.

FOR REAR BAGGING

Steps for setting up the mower for rear bagging.

FOR SIDE DISCHARGING

Steps for setting up the mower for side discharging.

BEFORE STARTING ENGINE

ADD OIL

Instructions for adding oil to the engine before operation.

ATTACH FUEL CAP CARTRIDGE

Instructions for attaching the fuel cap cartridge.

ADD GASOLINE

Guidance on safely adding gasoline to the fuel tank.

MOWING TIPS

Advice for optimal mowing performance and techniques.

MULCHING MOWING TIPS

Tips for achieving the best results when mulching grass.

MAINTENANCE SCHEDULE

LUBRICATION

LAWN MOWER

BLADE CARE

Instructions for maintaining and handling the mower blade.

TO REMOVE BLADE

Step-by-step guide to removing the mower blade.

TO REPLACE BLADE

Instructions for installing a new or sharpened mower blade.

TO SHARPEN BLADE

Guidance on sharpening and balancing the mower blade.

GRASS CATCHER

Care and maintenance of the grass catcher.

ENGINE LUBRICATION

Information on selecting and using the correct engine oil.

MAINTENANCE

TO CHANGE ENGINE OIL

Detailed steps for draining and refilling engine oil.

AIR FILTER

Instructions for cleaning or replacing the air filter.

MUFFLER

Information on inspecting and replacing the muffler.

SPARK PLUG

Guidance on replacing the spark plug.

CLEANING

Instructions for cleaning the mower housing and engine.

SERVICE AND ADJUSTMENTS

LAWN MOWER

General service and adjustment points for the mower.

REAR DEFLECTOR

Information on the rear deflector's function and replacement.

TO ADJUST HANDLE

Steps for adjusting the mower handle to different positions.

ENGINE

Engine-related service and adjustments.

STORAGE

LAWN MOWER

Instructions for preparing the mower for storage.

HANDLE

Steps for folding the mower handle for storage.

ENGINE FUEL SYSTEM

Precautions for storing the fuel system to prevent gumming.

ENGINE OIL

CYLINDER

OTHER

TROUBLESHOOTING

Does not start

Causes and corrections for engine not starting.

Loss of power

Reasons and solutions for reduced engine power.

Poor cut - uneven

Causes and corrections for an uneven grass cut.

Excessive vibration

Causes and corrections for excessive mower vibration.

Starter rope hard to pull

Causes and corrections for a hard-to-pull starter rope.

Grass catcher not filling (If so equipped)

Causes and corrections for the grass catcher not filling.

Hard to push

Causes and corrections for the mower being hard to push.

REPAIR PARTS

REPAIR PARTS (continued)

Craftsman 944.367412 Specifications

General

Engine Type	4-Cycle
Engine Displacement	140cc
Cutting Positions	6
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Power Source	Gas
Cutting Width	21 inches
Cutting Height	1.25-3.75 inches
Fuel Tank Capacity	0.5 gallons
Warranty	2 years limited