EasyManua.ls Logo

Craftsman 944.367742 - User Manual

Craftsman 944.367742
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Model No.
944.367742
CAUTION:
Read and follow all
Safety Rules and In struc tions
before operating this equipment
Owner’s Manual
ROTARY LAWN MOWER
675 Series Briggs & Stratton Engine
Power-Propelled
Electric Start
21" Multi-Cut
Sears Canada, Inc., Toronto, Ontario M5B 2B8

Questions and Answers

  • L
    Laura McdanielAug 12, 2025
    Why my Craftsman Lawn Mower does not start?
    • J
      Jay SandersAug 12, 2025
      Your Craftsman Lawn Mower might not start due to several reasons: * A dirty air filter. Clean or replace it. * Lack of fuel. Refill the fuel tank. * Stale or water-contaminated fuel. Empty and refill with fresh, clean gasoline. * A disconnected spark plug wire. Reconnect the wire. * A bad spark plug. Replace the spark plug. * A loose or broken blade adapter. Tighten the blade bolt or replace the adapter. * The control bar is not depressed. Depress the control bar to the handle. * A defective control bar. Replace it. * The fuel valve lever is in the OFF position. Turn it to ON. * A weak battery (if equipped). Charge the battery. * A disconnected battery connector (if equipped). Connect the battery to the engine.
  • J
    Jeffrey MclaughlinAug 16, 2025
    Why is my Craftsman 944.367742 losing power?
    • M
      Mark HoffmanAug 16, 2025
      If your Craftsman Lawn Mower is losing power, consider these potential causes: * The rear of the mower housing or blade may be dragging in heavy grass. Try raising the cutting height. * You might be cutting too much grass at once. Increase the cutting height. * The air filter could be dirty. Clean or replace it. * There might be a buildup of grass, leaves, and trash under the mower. Clean the underside of the mower housing. * There may be too much oil in the engine. Check the oil level. * Your walking speed could be too fast. Cut at a slower pace.
  • J
    Jessica ClarkAug 19, 2025
    How to fix poor uneven cut from Craftsman 944.367742 Lawn Mower?
    • C
      carolynmccormickAug 20, 2025
      An uneven cut with your Craftsman Lawn Mower can be caused by: * A worn, bent, or loose blade. Replace the blade and tighten the blade bolt. * Uneven wheel heights. Set all wheels at the same height. * Buildup of grass, leaves, and trash under the mower. Clean the underside of the mower housing.
  • T
    Terry ToddAug 25, 2025
    Why is the starter rope hard to pull on my Craftsman Lawn Mower?
    • J
      Joshua Reed DVMAug 25, 2025
      If the starter rope on your Craftsman Lawn Mower is hard to pull, it could be due to: * The engine flywheel brake being engaged when the control bar is released. Depress the control bar to the upper handle before pulling the starter rope. * A bent engine crankshaft. * A broken blade adapter. Replace the blade adapter. * The blade dragging in grass. Move the lawn mower to cut grass or to a hard surface.
  • E
    Elizabeth DuncanAug 27, 2025
    Why is my Craftsman 944.367742 Lawn Mower so hard to push?
    • N
      Nathaniel FosterAug 27, 2025
      If your Craftsman Lawn Mower is hard to push, consider the following: * The grass may be too high, or the wheel height may be too low. Raise the cutting height. * The rear of the mower housing or cutting blade might be dragging in the grass. Raise the rear of the mower housing one setting higher. * The grass catcher could be too full. Empty the grass catcher. * The handle height position might not be right for you. Adjust the handle height to suit your comfort.
  • P
    Patricia SilvaAug 31, 2025
    What to do if Craftsman Lawn Mower losing drive?
    • D
      Dr. Nancy Walsh MDAug 31, 2025
      If your Craftsman Lawn Mower is experiencing a loss of drive or slowing drive speed, check for: * Belt wear. Check or replace the drive belt. * The belt being off the pulley. Check and reinstall the drive belt. * A worn or broken drive cable. Replace the drive cable. * A loose drive control system. Adjust the drive control.
  • W
    Wesley WilkersonSep 3, 2025
    Why is my Craftsman 944.367742 Lawn Mower vibrating so much?
    • L
      Leslie YoungSep 4, 2025
      Excessive vibration in your Craftsman Lawn Mower may be due to: * A worn, bent, or loose blade. Replace the blade and tighten the blade bolt. * A bent engine crankshaft.
  • G
    Gina MooreSep 8, 2025
    What to do if grass catcher not filling on Craftsman 944.367742?
    • R
      redwardsSep 8, 2025
      If the grass catcher on your Craftsman Lawn Mower is not filling, it could be due to: * The cutting height being too low. Raise the cutting height. * The lift on the blade being worn off. Replace the blade. * The catcher not venting air. Clean the grass catcher.

Summary

SAFETY RULES

GENERAL OPERATION

Guidelines for safe and correct operation of the lawn mower.

SLOPE OPERATION

Precautions and techniques for safely mowing on sloped terrain.

CHILDREN SAFETY

Safety measures to prevent accidents involving children during operation.

SAFE HANDLING OF GASOLINE

Instructions for the safe storage and use of gasoline fuel.

PRODUCT SPECIFICATIONS

ASSEMBLY; PRE-OPERATION

REMOVING MOWER FROM CARTON

Step-by-step instructions for safely removing the mower from its packaging.

UNFOLDING AND SETTING UP THE MOWER HANDLE

Procedure for unfolding and adjusting the mower's handle for use.

INSTALLING ATTACHMENTS

Guidance on attaching optional accessories to the lawn mower.

BATTERY PREPARATION AND CHARGING

Instructions for charging the electric start battery before initial use.

ASSEMBLING THE GRASS CATCHER

Steps to assemble and attach the grass catcher accessory.

OPERATION

KNOW YOUR LAWN MOWER

Familiarization with the mower's controls, symbols, and features.

CPSC SAFETY REQUIREMENTS

Details on how the mower meets Consumer Product Safety Commission standards.

STARTING THE ENGINE

Step-by-step instructions for starting the lawn mower engine.

MOWING TECHNIQUES AND TIPS

Advice for effective mowing, including grass conditions and speed.

MULCHING MOWING TECHNIQUES

Tips for optimal performance and results when mulching grass clippings.

HOW TO USE YOUR LAWN MOWER

ENGINE SPEED AND CONTROL

Information on engine speed settings and the operator presence control system.

DRIVE CONTROL SYSTEM

Explanation of how to operate the self-propelling drive control system.

ADJUSTING CUTTING HEIGHT

Instructions for setting the lawn mower's cutting height for optimal performance.

ACCESSORY OPERATION

ATTACHING AND EMPTYING GRASS CATCHER

How to properly attach, use, and empty the grass catcher.

CONVERTING MOWER MODES

Steps to convert the mower between mulching, bagging, and discharging modes.

BEFORE STARTING ENGINE

ADDING ENGINE OIL

Procedure for checking and adding the correct type and amount of engine oil.

ATTACHING FRESH START FUEL CAP

Instructions for installing and using the special fuel cap system.

ADDING GASOLINE

Guidelines for safely filling the fuel tank with the appropriate gasoline.

MAINTENANCE

MAINTENANCE SCHEDULE

A schedule outlining routine checks and services for the lawn mower.

GENERAL MAINTENANCE RECOMMENDATIONS

Advice on warranty, periodic adjustments, and general upkeep practices.

PRE-USE CHECKS

Essential checks to perform on the mower before each use for safety and performance.

LUBRICATION GUIDELINES

Information on where and how to lubricate the lawn mower components.

TIRE AND WHEEL CARE

Instructions for maintaining the tires and drive wheels of the mower.

BLADE MAINTENANCE AND REPLACEMENT

Guidance on caring for, sharpening, and replacing the mower blade.

GRASS CATCHER CARE

Tips for checking and maintaining the condition of the grass catcher.

GEAR CASE MAINTENANCE

Procedures for cleaning and maintaining the mower's gear case.

ENGINE SERVICE

ENGINE OIL LUBRICATION AND CHANGE

Detailed steps for checking, changing, and lubricating the engine oil.

AIR FILTER MAINTENANCE

Instructions for cleaning or replacing the engine's air filter element.

MUFFLER INSPECTION

Guidance on inspecting the muffler for corrosion and potential hazards.

SPARK PLUG REPLACEMENT

Information on replacing the spark plug for optimal engine starting and running.

CLEANING AND SERVICE

GENERAL LAWN MOWER CLEANING

Procedures for cleaning the mower's exterior and underside after use.

CLEANING UNDER DRIVE COVER

Instructions for cleaning debris from the underside of the drive cover.

SERVICE AND ADJUSTMENTS OVERVIEW

General safety precautions and overview of service adjustments.

REAR DEFLECTOR INSPECTION

Guidance on inspecting the rear deflector for damage or wear.

REPLACING THE DRIVE BELT

Step-by-step instructions for removing and replacing the mower's drive belt.

ADJUSTING THE HANDLE HEIGHT

How to adjust the handle to different height positions for user comfort.

ENGINE SPEED AND CARBURETOR DETAILS

Information regarding engine speed limits and carburetor adjustability.

STORAGE PROCEDURES

LAWN MOWER PREPARATION FOR STORAGE

Steps for cleaning, lubricating, and preparing the mower for long-term storage.

FOLDING THE HANDLE FOR STORAGE

Instructions on how to fold the mower handle for compact storage.

ENGINE FUEL SYSTEM STORAGE

Guidance on preparing the fuel system for storage to prevent gumming.

ENGINE OIL AND CYLINDER PREPARATION FOR STORAGE

Steps to protect the engine cylinder and oil during storage.

BATTERY STORAGE

Instructions for properly storing the mower's battery.

GENERAL STORAGE PRECAUTIONS

Important safety warnings and tips for storing the lawn mower.

TROUBLESHOOTING

ENGINE FAILS TO START

Common causes and corrections for the engine not starting.

ENGINE LOSS OF POWER

Troubleshooting steps for when the engine experiences a loss of power.

POOR CUT QUALITY AND VIBRATION

Diagnosing and resolving issues related to uneven cutting or excessive vibration.

STARTING AND DRIVING PROBLEMS

Solutions for issues like hard-to-pull starter ropes or drive system problems.

GRASS CATCHER AND PUSHING ISSUES

Addressing problems with the grass catcher not filling or the mower being hard to push.

REPAIR PARTS IDENTIFICATION

ENGINE REPAIR PARTS

ENGINE SPECIFICATIONS

ENGINE POWER RATING INFORMATION

Explanation of how engine power ratings are determined and factors affecting performance.

SERVICE NOTES

Craftsman 944.367742 Specifications

General IconGeneral
EngineBriggs & Stratton
Drive SystemSelf-Propelled
Deck MaterialSteel
Mulching CapabilityYes
Bagging CapabilityYes
Side DischargeYes
Cutting Width21 inches
Discharge OptionsSide, Mulch
Cutting Height1.25 to 3.75 inches
Wheel Size8 inches front, 11 inches rear

Related product manuals