This product will accept Craftsman 19.2V C3 lithium-ion battery packs. For
complete charging instructions, refer to the Operator's Manuals for the battery
pack and charger.
WARNING: Do not direct the light beam at persons or animals and do not
stare into the light beam yourself (even from a distance). Staring into the light
beam may result in serious injury or vision loss.
TO ATTACH BATTERY PACK (Fig. 2)
1. Ensure that the on/off switch
is in the "OFF" position.
2. Align the raised rib on the
battery pack with the groove
inside the worklight, and then
insert the battery pack into
the appliance.
NOTICE: Make sure that the
latch on the battery pack snaps
into place and the battery pack is
secured to the appliance before
beginning operation. Improper
assembly of the battery pack can
cause damage to internal components.
Fig. 2
Rib
:h
3attery-
aase Button
TO DETACH BATTERY PACK (Fig. 2)
1.
2.
3.
TURN ON/OFF THE
WORKLIGHT (Fig. 3)
With the worklight facing you as
shown in Fig. 3:
Push the On/Off switch to the Left
to turn the worklight ON.
Push the On/Off switch to the
Right to turn the worklight OFF.
Ensure that the on/off switch is in the "OFF" position.
Depress both battery-release buttons, located on the sides of the battery
pack, to release the battery pack.
Pull the battery pack out and remove it from the appliance.
On/off Switch
Fig. 3
Off _ On
To Next Page
Loading...
Need help?
General
