ADJUSTING THE WORKLIGHT
HEAD (Fig.4)
The worklight head independently
pivots 200 ° for maximum
flexibility.
Move the head by manually
adjusting it to any position within
the 200 ° pivot range. Do not force
the head beyond the 200 ° range.
Fig. 4
A
WARNING: To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
WARNING: Always wear safety goggles or safety glasses with side shields
when using compressed air to clean the tool. If the operation is dusty, also wear a
dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible
to damage from various types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
WARNING: When servicing, use only identical craftsman replacement parts.
Use of any other parts may create a hazard or cause product damage. To ensure
safety and reliability, all repairs should be performed by a qualified
service technician.
To Next Page
Loading...
Need help?
General
