To Next PageTo Next PageWhat causes uneven cut with Craftsman C459-60116?
An uneven cut with your Craftsman Lawn Mower may result from: * The deck not being leveled properly. Perform a side-to-side deck adjustment. * A dull blade. Sharpen or replace the blade. * Uneven tire pressure. Check the tire pressure in all four tires.
Why does my Craftsman C459-60116 Lawn Mower engine run erratically?
An erratic running engine in your Craftsman Lawn Mower can stem from: * The unit running with the CHOKE activated. Deactivate the CHOKE. * Loose spark plug wires. Connect the spark plug wires. * A blocked fuel line or stale fuel. Replace the fuel line, fill the tank with clean, fresh gasoline, and replace the fuel filter. * A plugged vent in the gas cap. Clear the vent or replace the cap if damaged. * Water or dirt in the fuel system. Drain the fuel tank and refill with clean, fresh gasoline. * A dirty air cleaner. Replace the air cleaner paper element or clean the foam pre-cleaner, if equipped.
What to do if Craftsman C459-60116 engine idles rough?
A rough idling Craftsman Lawn Mower engine could be caused by: * A spark plug that is fouled, faulty, or has a gap that is too wide. Replace the spark plug and set the plug gap. * A dirty air cleaner. Replace the air cleaner element and/or clean the pre-cleaner.
What to do if Craftsman Lawn Mower is not mulching grass?
If your Craftsman Lawn Mower isn't mulching grass effectively: * Ensure the engine speed isn't too low by placing the throttle in the FAST (rabbit) position. * Avoid mulching when the grass is wet. * If the grass is excessively high, mow once at a high cutting height, then mow again at the desired height, or make a narrower cutting swath. * Check if the blade is dull; sharpen or replace it.
Why Craftsman Lawn Mower engine overheats?
Your Craftsman Lawn Mower engine may overheat because: * The engine oil level is low. Fill the crankcase with the proper amount and weight of oil. * Air flow is restricted. Clean grass clippings and debris from around the engine’s cooling fins and housing.
How to fix excessive vibration in Craftsman C459-60116?
Excessive vibration in your Craftsman Lawn Mower can be due to: * A loose or unbalanced cutting blade. Tighten the blade and spindle. * A damaged or bent cutting blade. Replace the blade.
Why does Craftsman Lawn Mower engine hesitate at high RPM?
If your Craftsman Lawn Mower engine hesitates at high RPM, it could be because the spark plug gap is too close. Remove the spark plug and reset the gap.
General| Brand | Craftsman |
|---|---|
| Model | C459-60116 |
| Category | Lawn Mower |
| Language | English |
Follow operating instructions, general safety rules, and exercise caution on slopes.
Covers safety for children, towing, service, engine modifications, and emissions.
Understand safety symbols and use the slope guide for safe operation.
Manual movement, brace removal, battery, tires, deck gauge, seat, and fluids.
Identifies and describes the tractor's main controls and features.
Explains operation of ignition, drive pedals, indicators, PTO, and parking brake.
Procedures for starting, driving, and safely stopping the tractor.
Understanding safety interlocks, reverse mode, and slope operation.
Use of speed controls, parking brake, cruise control, and mowing tips.
A chart detailing service intervals and required maintenance tasks.
Procedures for deck removal, belt change, and blade service.
Service for battery, engine oil, air cleaner, fuel filter, fuse, and tires.
Tractor cleaning, lubrication points, and various adjustments.
Steps for preparing the tractor and engine for storage.
