Craftsman CMXGRAM1130044

Questions and Answers

K
Karen GrayAug 10, 2025
Why does my Craftsman CMXGRAM1130044 leave an uneven cut?
- R
  Ryan RollinsAug 10, 2025
  An uneven cut from your Craftsman Lawn Mower may be caused by: 1. The deck not being leveled properly: Perform a side-to-side deck adjustment. 2. A dull blade: Sharpen or replace the blade. 3. Uneven tire pressure: Check the tire pressure in all four tires.
J
Juan MorganAug 14, 2025
What to do if my Craftsman CMXGRAM1130044 Lawn Mower engine runs erratically?
- L
  Lisa DixonAug 14, 2025
  If your Craftsman Lawn Mower engine is running erratically, consider the following: * Check that the electric choke is working. * Ensure spark plug wires are connected and tightened. * The fuel line might be blocked or the fuel stale. Replace the fuel line and fill the tank with clean, fresh gasoline. * The vent in the gas cap might be plugged. Clear the vent or replace the cap if damaged. * There might be water or dirt in the fuel system. Drain the fuel tank and refill with clean, fresh gasoline. * The air cleaner might be dirty. Clean or replace the air cleaner paper element or clean the foam pre-cleaner.
K
knormanAug 18, 2025
Why is my Craftsman CMXGRAM1130044 engine overheating?
- J
  jay05Aug 18, 2025
  Your Craftsman Lawn Mower engine may be overheating because: 1. The engine oil level is low: Fill the engine with the proper amount and type of oil. 2. Air flow is restricted: Clean grass clippings and debris from around the engine’s cooling fins and blower housing.
K
Kimberly WiseAug 22, 2025
How to fix excessive vibration in Craftsman CMXGRAM1130044?
- M
  Megan FritzAug 23, 2025
  Excessive vibration in your Craftsman Lawn Mower can be due to: 1. Cutting blades being loose or unbalanced: Tighten the blade and spindle, and balance the blade. 2. A damaged, dull, or bent cutting blade: Replace the blade.
G
greenstevenAug 27, 2025
What causes a Craftsman Lawn Mower engine to idle poorly?
- S
  Susan HillAug 27, 2025
  A Craftsman Lawn Mower engine may idle poorly due to: 1. A fouled spark plug: Replace the spark plug and adjust the gap. 2. A dirty air cleaner: Clean or replace the air cleaner element and/or clean the pre-cleaner.
D
Daniel ChangAug 31, 2025
What to do if Craftsman Lawn Mower won't mulch grass?
- R
  ryoungAug 31, 2025
  If your Craftsman Lawn Mower won't mulch grass, check these possible causes: 1. Engine speed too low: Place the throttle control in the FAST position. 2. Wet grass: Avoid mulching when the grass is wet. 3. Excessively high grass: Mow once at a high cutting height, then mow again at the desired height or make a narrower cutting swath. 4. Dull blade: Sharpen or replace the blade.
E
Erin BurchNov 5, 2025
Why won't my Craftsman CMXGRAM1130044 Lawn Mower engine start?
- E
  Emily PriceNov 5, 2025
  Your Craftsman Lawn Mower engine might fail to start due to several reasons. Here's what you can check: * The PTO/Blade Engage knob might be engaged: Place it in the disengaged (OFF) position. * The parking brake might not be engaged: Engage the parking brake. * The spark plug wire might be disconnected: Connect the wire to the spark plug. * The throttle control lever might not be in the correct starting position: Place the throttle lever to the FAST position. * The fuel tank might be empty or contain stale fuel: Fill the tank with clean, fresh gasoline (less than 30 days old). * The fuel line might be blocked: Replace the fuel line. * The spark plug might be faulty: Clean, adjust the gap, or replace the plug. * The engine might be flooded: Crank the engine with the thrott...