EasyManuals Logo

Craftsman evolv 113.175550 User Manual

Craftsman evolv 113.175550
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Maintenance
Filter
WARNING: To reduce the risk of
injury from accidental starting, unplug
power cord before changing or
cleaning filter.
NOTE: This filter is made of high quality
paper designed to stop very small parti-
cles of dust. The filter can be used for
small amounts of liquid pick up or dry
pick up. Handle the filter carefully when
removing to clean or installing it. Creases
in the filter pleats may occur from installa-
tion but creases will not affect the per-
formance of the filter.
Filter Cleaning
Your filter should be cleaned often to
maintain peak vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use
a filter with holes or tears in it. Even a
small hole can cause a lot of dust to
come out of your vac. Replace it
immediately.
Filter Removal and Replacement
WARNING: Do not operate without
filter cage and float, as they prevent
liquid from entering the impeller and
damaging the motor. For dry material
pick-up, do not operate without the fil-
ter in place to reduce the risk of dam-
age to the motor.
Filter Installation:
1. Carefully slide the Qwik Lock TM filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the filter
seats securely around the base of the
filter cage and against the lid.
2. Align the small center hole in the top of
the filter over the Qwik Lock TM stud on
the filter cage. Press firmly on top of
the filter near the stud to allow the filter
to snap over the ball on the end of the
stud. The filter is now attached.
integrated
Filter Plate PUSH
with Center.. DOWN PULL
Hole _ uP
Filter _'_Rubber
Tabs(2)IIIIIIIIIIIII Gasketat
IIIIIIIIIIIII Bottom of
I_.__._. LIIIJlIIIII[I Filter (cutaway
__)) ___._'---_ awik Lock TM
Filter j _
NOTE: Failure to properly seat the
bottom gasket could result in debris
bypassing the filter.
Filter Removal:
1. Hold the filter tabs of the Qwik Lock TM
filter in each hand.
2. With one thumb on the Qwik Lock TM
stud, which protrudes through the inte-
grated filter plate, lift up on the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Craftsman evolv 113.175550 and is the answer not in the manual?

Craftsman evolv 113.175550 Specifications

General IconGeneral
BrandCraftsman
Modelevolv 113.175550
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals