To Next PageTo Next Page
Need help?Do you have a question about the Craftsman weedwacker 358.798420 and is the answer not in the manual?
General| Engine Type | 2-Cycle |
|---|---|
| Cutting Width | 17 inches |
| Cutting Swath | 17 inches |
| Shaft Type | Straight |
| Line Diameter | 0.095 inch |
Essential safety practices for the user, including protective gear and avoiding distractions.
Safety guidelines for the unit itself and during maintenance tasks.
Precautions for handling and using gasoline and oil mixtures.
Safety measures related to the cutting process and thrown objects.
Guidelines for safe transport and storage of the unit.
Important warnings and explanations of safety symbols.
List of tools needed for assembling the unit.
Steps for safely removing the unit from its packaging.
Instructions for attaching and adjusting the assist handle.
Steps for properly installing the debris shield for safety.
Procedure for assembling the cutting head unit.
Identification of unit controls and components.
Specific safety warnings for line trimmer operation.
Safety precautions related to the unit's overall function.
Procedures for safely shutting down the engine.
Explanation of throttle, choke, and primer controls.
How to adjust the assist handle for balance and control.
Method for advancing the trimmer line during use.
Specifications for fuel type and mixture.
Step-by-step guide for mixing fuel and oil.
Information on using fuel stabilizer for storage.
Details on the specific type of engine oil required.
Step-by-step guide for starting the engine.
Troubleshooting steps for engine starting issues.
Various methods for trimming, scalping, mowing, and sweeping.
A timeline for regular service and checks.
Overall advice for maintaining the unit and warranty.
Checks to perform before each use of the unit.
Cleaning procedures after using the unit.
Guide for lubricating the drive shaft and other components.
Maintenance tasks required every 5 hours of use.
Maintenance tasks required every 25 hours of use.
Detailed steps for lubricating the drive shaft.
Annual maintenance tasks for optimal performance.
Procedure for replacing the fuel filter.
Instructions for replacing trimmer line and spools.
Steps for installing pre-wound and new line spools.
Steps for tuning idle speed, mixture, and acceleration for optimal performance.
General cleaning and preparation for storage.
Procedures for draining and preparing the fuel system.
Steps for preparing the engine for long-term storage.
General advice on storage location and conditions.
A table listing symptoms, causes, and corrections for common problems.
