Craig CVD401A - System Setup; Navigating Setup Menus; General, Audio, and Video Configuration

SYSTEM SETUP
Setting Menus:
menu will appear on the screen as below.
Using the Direction
◄, ►, ▲, ▼
you need to set or reset. Press
the
ENTER Button to enter or confirmed
the
selection. After setting, press the SET UP
Button to
save
the settings and exit.
General
Audio
Dolby
Video
General Setup Page
Go To General Setup Page
preferences
TV Display Wide
Angle Mark On
OSD Lang ENG
Screen Saver On
the multi-angle logo will appear on the screen.
3. If OSD Lang (On Screen Display Language) is selected, using the
TV.
On or Off. If set to On, when
multi-angles are available in the playing DVD,
and ENTER Buttons to set the
OSD language as desired.
4. If Screen Saver is selected, using the Direction and ENTER Buttons to set
it On or Off.
If set to On, the screen saver will come on when the unit stops or the image is paused for approximately
five minutes.
Audio Setup Page:
General Setup Page:
channel on all speakers) or Mix-Mono
plays on all speakers) as desire. (Functions depend on the recording of
the disc).
to Stereo, L-Mono (Play Left
channel on
all speakers), R-Mono (Play Right
(Mixed Right and
Left channel then
dynamic level as desire or
turn it off.
Dolby Digital Page:
1. If TV Display is selected, using the Direction and ENTER Buttons to set the aspect ratio to
Normal/PS (4:3); Normal/LB (4:3 Letter Box) or Wide (16:9) to
to English; French, Germany or Spanish
1. If Downmix is selected, using the Direction and ENTER Buttons to set it to LT/RT or Stereo.
mtach the connected
Press the SETUP Button, the setting
2. If Angle Mark is selected, using the Directionand ENTER Buttons to set it
Direction
~ If set to LT/RT, the rear left or rear right channels in Dolby 5.1 recording DVD will plays on both Left and Right Speakers.
~ If set to Stereo, the rear left channel will plays on Left Speaker; the rear right channel will plays on Right Speaker.
Note: Function depends on the recording of disc.
1. If Dual Mono is selected, using the Di
2. If Dynamic is selected, using the Di
rection and ENTER Buttons to set it
rection and ENTER Buttons to set the
Buttonsto select and highlight the function
Setup
-17-