OPERATIONS
Playback of a DVD:
Connect the DVD Player to the TV as previous procedures.
AC/DC Adaptor to the DC IN Jack on the rear of Player.
Insert the AC/DC Adaptor into a conveniently located AC outlet having The Red
Standby Indicator on the front cabinet will turn on.
3. Press the Button on the Player or Remote Control to turn the Player on from standby mode.
4. Press the OPEN/CLOSE ( ) Button to open the disc tray. Place the disc on the center of tray with
label side face up. Closed the tray by press the OPEN/CLOSE ( ) Button. The unit will start
playback automatically.
6. Press the STOP Button to stop playback. The player will remember the point where disc was stopped. When
Press the Play/Pause Button again, playback will start from this point. To stop playback completely or to start
Button twice.
NOTE: If the player will not be used for a long period of time, power off the player and unplug
the AC/DC adaptor from wall outlet.
7. To power off, press the Button to turn off (standby mode) the player. The color of the STANDBY Indicator
will turn to red.
5. During playback:
~ Press the or Buttons repeatedly to search for a specific section forward/backward.
Press Play/Pause Button to resume normal playback.
~ Press the or Buttons repeatedly to skip to specific tracks/chapters.
~ Press Play/Pause Button to pause, press again to resume normal playback.
-11-
OPagain from the beginning, press ST
2.
Insert the small plug from the supplied
1.
AC 100-240V~, 50/60Hz.
The color of STANDBY
Indicator on the front cabinet will turns to green.
~ Press the VOLUME +/- Button to adjust volume level.
To Next Page
Loading...
