OPERATI NG I NSTRUCTIONS
The Heavy-Duty
Undercut Saw is designed for
undercutting
wooden
door
jambs,
moldings,
base, as well
as masonry
and stone, to ailow new floor
dovering5 to be fit
underneath'.
Do not use this
saw
for
sanding floors,
cutting metal,
or any
other
purpose
not
described in this instruction
manual.
SAFEW FIRST! For
safe operation,
please
take
time to
carefully read allthe instructions
and rules in this
booklet.
SAFETY
GLASSES:
Always wear
safety
glasses
when
using a
power
tool. Also
use
face
or dust mask if
cutting
operation is
dusty.
EAR PROTECTION:
Wear ear
plugs
when
using
this
saw.
BLADE
GUARD: The blade
guard
attached
to
your
saw
is
for
your
safety and
protection.
lf it
becomes damaged,
do
not
operate
your
saw
until
it has
been
repaired.
Always leave
blade
guard
in operating
position
when
using the
saw.
DOUBLE-INSULATED:
This tool is constructed with
two
separate
layers
of electrical
insulation.
Atool built with this
insulation
system does not need
to
be
grounded.
DANGEROUS
ENVIRONMENTS: Keep work
area clean;
clutter invites accidents. Do not
use
power
tool
on damp
or wet floor. Be sure that there is
good
lighting.
ACCIDENTAL STARTING: To
avoid accidental starting, do
not carry tool with fingers
on switch.
CORD ABUSE: Never
carry
tools by the cord
or
yank
the
cord
to
disconnect
from
an outlet.
Keep
cords away from
heat,
oil, and sharp edges.
EXTENSION
CORD:
To minimize
power
loss
and
prevent
overheating, use
maximum
of
25 feet long
and
16
AWG.
KEEP BLADES
CLEAN AND SHARP: Using a dull blade
will
place
a heavy
load
on
your
saw and
increase
the danger
of
kickback. For replacement,
use only Crain
#821
Carbide-
Tipped Blade,
#805
Masonry Blade or#822 Diamond Blade.
WORKING TERMINOLOGY Fisure 1
Please refer to the
diaoram
below for the terms
used
in
this instruction manual
HEIGHT
ADJUSTER
WING
NUT
DEPTH
GAUGE
ADJUSTMENT
SCALE
Figure 1
THREE-ARM
KNOB
To Next Page
Loading...
