What to do if my Cramer 2100186 Trimmer motor fails to start?
If your Cramer Trimmer's motor won't start when you press the switch trigger, there are a couple of things to check: First, make sure the battery pack is securely attached and that the latch on the bottom has snapped into place. Second, ensure that the battery is fully charged by following the charging instructions specific to your model.
Why won't the string advance on my Cramer 2100186?
If the string on your Cramer Trimmer won't advance when using the bump-feed head, there are several possible reasons. The string might be welded together, in which case you should replace it. Alternatively, there might not be enough string on the spool, so you should install more, referring to the string replacement instructions. It's also possible that the string is worn too short; try pulling the string while pressing the line release button. Finally, the string could be tangled on the spool, so you should remove it and rewind it, again referring to the string replacement instructions.
How to stop grass from wrapping around my Cramer Trimmer?
To prevent grass from wrapping around the shaft housing and string head of your Cramer Trimmer, avoid cutting tall grass at ground level. Instead, cut tall grass from the top down.
What to do if my Cramer Trimmer motor fails to start when I depress the switch trigger?
If the motor fails to start when you depress the switch trigger, there are a couple of things to check. First, make sure the battery is secure by ensuring the latch on the bottom of the battery pack snaps into place. Second, verify that the battery is charged. If not, charge it according to the instructions included with your model.
Why won't the string advance on my Cramer 2100186 Trimmer when using the bump-feed head?
There are several reasons why the string might not advance when using the bump-feed head. Here's what to check: 1. The string might be welded to itself, in which case you should replace it. 2. There might not be enough string on the spool, so install more string. 3. The string could be worn too short; try pulling the string while pressing the line release button. 4. The string could be tangled on the spool; remove the string and rewind it.
What to do if grass wraps around the shaft housing and string head of my Cramer 2100186 Trimmer?
If grass is wrapping around the shaft housing and string head of your Cramer Trimmer, it's likely due to cutting tall grass at ground level. To prevent this, cut tall grass from the top down.
To Next Page
General
