12
cramer.eu
EN
Technical Data
PROPERTY VALUE
VALUE
Model
82TB10 82TB16
No load speed
4500-5500-6500-
7000 /min
4500-5500-6500-
7000 /min
Cutting head Bump feed Bump feed
Cutting Line Diameter 2 mm 2 mm
Cutting Path Diameter 40 cm 46 cm
Battery pack
82V220G/82V430G/
82V220/82V430
82V220G/82V430G
82V220/82V430
Charger 82C1G/82C2/82C6 82C1G/82C2/82C6
Weight (without battery pack) 4.5 kg 5.5 kg
Measured sound pressure level
L
PA
＜
96 dB(A),
K
PA
=3 dB(A)
L
PA
＜
96 dB(A),
K
PA
=3 dB(A)
Measured sound power level
L
WA
＜
93 dB(A) L
WA
＜
93 dB(A)
Guaranteed sound power level 96 dB(A) 96 dB(A)
Vibration
< 2.5 m/s
2
,
k=1.5m/s
2
< 2.5 m/s
2
,
k=1.5m/s
2
Troubleshooting
PROBLEM
POSSIBLE
CAUSE
SOLUTION
String will not
advance when using
the bump-feed head.
String is
welded to
itself.
Replace string.
Not enough
string on
spool.
Install more string. Refer to string re-
placement earlier in this manual.
String is
worn too
short.
Pull string while pressing line release
button.
String is
tangled on
spool.
Remove string from spool and rewind.
Refer to string replacement earlier in this
manual.
Grass wraps around
shaft housing and
string head.
Cutting tall
grass at
ground level
Cut tall grass from the top down to
prevent wrapping.
Motor fails to start
when switch trigger
is depressed.
Battery is
not secure.
To secure the battery pack, make sure
the latch on bottom of the battery pack
snaps into place.
Battery is
not charged.
Charge the battery pack according
to the instructions included with your
model.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
To Next Page
Loading...
