13
PRODUCED IN CHINA FOR:
ALDI STORES LTD. PO BOX 26, ATHERSTONE,
WARWICKSHIRE, CV9 2SH.
ALDI STORES (IRELAND) LTD.
PO BOX 726, NAAS, CO. KILDARE.
Visit us at www.aldi.com
CHARGING YOUR SCOOTER
Step 1: Ensure that the charging port is clean and dry.
Step 2: Plug the charger into the power outlet, then connect the cable with the power
supply (100V ~ 240V; 50,60 Hz), make sure the light on the charger is lit GREEN.
Step 3: Connect the charging cable into the charging port of the scooter. The indicator
light on the charger should change to RED, indicating that your scooter is now
being charged. When the red indicator light on the charger turns to GREEN,
your scooter is fully charged. A full charge typically occurs within 3-4 hours. The
charger will automatically stop charging when the light is GREEN.
Step 4: Please unplug the charger from the scooter and from the power outlet.
NOTE:
If the GREEN light on the charger does not turn RED when you plug it into your scooter, check
that all the connections are properly connected or that the scooter is not already fully charged.
INSPECTION, MAINTENANCE AND STORAGE
Your scooter requires routine inspection and maintenance. This chapter describes
maintenance steps and important operating tips. Before you perform the following
operations, ensure the power and charging cable is disconnected.
Inspecting your scooter
Before you ride the scooter; check that the front wheel is properly aligned and connected
to the handlebars. Position the front wheel between your feet and gently move the
handle bar from side to side to check wheels follows the handle bars. If any problems,
contact after sales support.
Routinely check the body of the scooter and tyres for damage or excessive wear, check
all bolts and screws and tighten them if needed.
Cleaning your scooter
Disconnect the charger and turn off your scooter.
Avoid using water or other liquids and cleaners on the scooter while cleaning. Wet a
clean cloth with clean soapy water, wring out the cloth thoroughly, and wipe the body of
the scooter, making sure that water does not get into the power button, charging port,
the foot mats, locking mechanism or tyres.
Storing your scooter
Fully charge your battery before storing.
If you are storing your scooter for an extended period of time, please fully charge your
scooter at least once every three months.
If the ambient temperature of the storage location is below 0°, please do not charge. You
must bring the scooter into a warmer environment before charging. Check under Battery
Information and Specications for more details.
To prevent dust from getting into your scooter, try wrapping it or sealing it with its
original packaging.
Store your scooter indoors, in a dry and suitable temperature.
To Next Page
Loading...
General