First use
34
Set both the lengths of your walking and run-
ning stride regardless whether you only intend
to walk or run. This will ensure that the measure-
ments are as accurate as possible. Otherwise, the
pulse watch will use default values that do not
correspond to your personal movement profile.
14. To confirm your selection, push the “MODE” button.
The “DAILY RESET” indicator will appear.
15. To configure whether the pulse watch should reset the
measured data daily, select “ON” or “OFF”, by pushing the
“ST./STP.” button or “SELECT” button.
16. Hold down the “MODE” button for approx. 3 seconds.
All settings will be saved.
To Next Page
Loading...
