Crane PULSE WATCH - Page 67

Main modes
67
Time measurement addition
1. To start time measurement, push the “ST./STP.” button
2
.
2. To stop time measurement, push the “ST./STP.” button
again.
3. To resume the time measurement at the recorded time,
push the “ST./STP.” button again.
− To reset the time to zero, stop the stop watch and hold the
“SELECT” button
4
down for approx. 3 seconds.
Recording interim time
1. To start time measurement, push the “ST./STP.” button
2
.
2. To show an interim time, push the “SELECT” button
4
.