Need help?Do you have a question about the Crate G120CXL and is the answer not in the manual?
General| Technology | Solid State |
|---|---|
| Effects | Reverb |
| EQ | 3-Band (Bass, Mid, Treble) |
| Reverb | Yes |
| Type | Guitar Combo Amplifier |
| Power Output | 120 Watts RMS |
Details on 0 dB and -6 dB input jacks for connecting various signal sources.
Sets the gain for Channel A, used to vary the amount of distortion from minimal to maximum.
Controls the overall volume of Channel A, used in conjunction with the Gain Control.
Tone control for Channel A, affecting midrange, lows, and highs for desired sound.
Switch to select between Channel A and Channel B, inoperative with footswitch.
Sets the gain for Channel B, for overdriven, distorted, or clean sounds.
Controls the overall volume of Channel B, used with the Gain Control.
Adjusts Bass, Midrange, and Treble frequencies for Channel B's tonal quality.
Adds brilliance and sharpness to the guitar's sound.
Alters the apparent acoustical qualities of a room for the reverb effect.
Output for external effects loop or processing, signal level allows pedal effects.
Input for external effects loop or acts as a direct input, disconnecting normal signal.
Controls for the stereo chorus effect, including switch, depth, and rate.
Main power switch and LED indicator for amplifier status.
Connects for channel/reverb and chorus footswitches.
Standard stereo headphone jack for private listening, chorus in stereo.
Connects to additional amplifiers or tape recorder/mixing board for stereo signal.
Direct input to power amp, used with Line Out for effects loop or as input.
Connects external speakers, minimum 2 ohms load impedance per side.
Turns off internal speakers for private headphone listening.
Heavy-duty grounded three-wire power cord for safe operation.
Specifies output power rating, THD, impedance, and speaker configuration.
Details on Bass, Mid, Treble control ranges and input impedance values.
Maximum input signal levels accepted and total system gain figures.
Provides signal to noise ratio for both Channel A and Channel B.
Specifies input power requirements and physical cabinet size and weight.
Cautions regarding electric shock, user serviceable parts, and hearing protection.
To Next Page
