Crate TAXI TX-30E - Technical Specifications

©2001 SLM Electronics • A division of St. Louis Music
1400 Ferguson Avenue • St. Louis, MO 63133
P/N 47-459-02 • 03/01
CRATE TAXI • TX-30E
TECHNICAL SPECIFICATIONS
OUTPUT POWER RATING 30W RMS @ 10% THD, 8 ohms, 13.6VDC in
INPUT IMPEDANCE 1M ohm
MAXIMUM SIGNAL ACCEPTED
Channel 1 6V peak to peak
Channel 2 12V peak to peak
GAIN Channel 1 64dB
Channel 2 56dB w/Gain switch out
86dB w/Gain switch in
SENSITIVITY Channel 1 9mV RMS
Channel 2 20mV RMS w/Gain switch out
.7mV RMS w/Gain switch in
Line In Insert .3V RMS
TONE, CHANNEL 1 +/–15dB @ 600Hz
EQS, CHANNEL 2 Low 12.5dB range @ 80Hz
Mid 18dB range @ 850Hz
High 13dB range @ 6kHz
INSERT JACK Tip Line In
Ring Line Out
Sleeve Ground
SPEAKERS Woofer Crate Custom Design 8”, 8 ohm, 50 watt
1” voice coil
Tweeter 2” Piezo, 8 ohm, 50 watt
POWER REQUIREMENTS Internal 12 volt DC power supply
DC adapter for use with 120VAC
Optional 12V vehicle lighter adapter
SIZE AND WEIGHT 17”W x 12-1/2”H x 12-1/2”D; 17 lbs.
The TX-30E is enclosed in a rugged, molded high tech polymer cabinet. Wipe
the enclosure with a damp, lint-free cloth to remove dirt and road film. Never
spray cleaning agents directly onto the enclosure, and stay away from abra-
sive cleansers which could damage the finish.
Crate continually develops new products, as well as improves existing ones. For this reason,
the specifications and information in this manual are subject to change without notice.
www.crateamps.com