Need help?Do you have a question about the Crate TD-50C and is the answer not in the manual?
OdB and -6dB input jacks for connecting signal sources.
Drive sets the gain and distortion level for Channel A.
Reverb controls the amount of reverb effect.
Heavy-duty grounded three-wire power cord for safe operation.
For additional speaker hookup, in series with internal speakers.
Overall tone control for Channel A, affects midrange or highs/lows.
Indicates when the amplifier is in Channel A mode.
Sets overall volume, used with Drive control.
Selects signal through Channel A or Channel B.
Sets gain for Channel B; lower for clean, higher for distortion.
Low and Mid controls adjust frequency tone for Channel B.
Chorus switch, Depth, and Rate controls for chorus effect.
Power switch and indicator LED for turning the unit on/off.
Stereo 'Y' cord jack for effects loop (line in/out).
Carry preamp signal for recording, with stereo/mono mix options.
For chorus and channel select/reverb footswitches.
Specifies output power rating and speaker size/type.
Details tone control ranges and input impedance values.
Specifies total system gain and signal-to-noise ratios.
Lists power requirements, size, and weight of the unit.
To Next Page
General
