Need help?Do you have a question about the Crate TX15 and is the answer not in the manual?
Power| output power rating | 15W RMS @ 10% THD, 4 ohms, 13.6VDC in |
|---|---|
| power requirements | Internal 12 volt DC power supply |
| DC adapter | for use with 120VAC |
Audio Input| input impedance | 20k ohm |
|---|---|
| maximum signal accepted Input 1 Hi-Z | 8V peak to peak, 2.75V RMS |
| maximum signal accepted Input 1 Lo-Z | 1.2V peak to peak, 40mV RMS |
| maximum signal accepted Input 2 | 8V peak to peak, 2.75V RMS |
| gain Input 1 Hi-Z | 52dB |
| gain Input 1 Lo-Z | 68dB |
| gain Input 2 | 52dB |
| sensitivity Input 1 Hi-Z | 12mV RMS |
| sensitivity Input 1 Lo-Z | 1.75mV RMS |
| sensitivity Input 2 | 12mV RMS |
Equalization| low EQ | ±15dB @ 70Hz |
|---|---|
| low mid EQ | ±12dB @ 385Hz |
| high mid EQ | ±10dB @ 1.85kHz |
| high EQ | ±15dB @ 10kHz |
Speakers| woofer | Crate Custom 8”, 4 ohm, 15 watt, 1” voice coil |
|---|---|
| tweeter | 2” Piezo |
Weight and Dimensions| dimensions | 14.5”W x 11.75”H x 12”D |
|---|---|
| weight | 20 lbs. |
Covers risk of electric shock, fire, and exposure to liquids, along with general caution notices.
Provides essential safety guidelines for operating the amplifier, including warnings about water, heat, and proper use.
Explains the meaning of graphical symbols used in the manual to highlight potential hazards.
Details the main capabilities and components of the Crate TX15 amplifier.
Illustrates the recommended way to connect instruments and audio sources to the amplifier.
Explains the internal battery system, charging process, and power adapter functionality.
Describes each control knob, button, and input/output jack on the front of the amplifier.
Details the DC charger plug and battery status LED located on the rear of the amplifier.
Provides a visual representation of the amplifier's internal signal paths and power supply circuit.
Lists comprehensive technical data, including power output, impedance, sensitivity, and dimensions.
Outlines the standards and regulations the amplifier complies with, such as LVD and EMC.
To Next Page
