Output Power Rating 50W RMS @ 10% THD, 8 ohm load, 120 VAC
Input Impedance 1M ohm
Maximum Signal Accepted 2.8V peak to peak
Signal To Noise Ratio Channel B: 52dB
Channel A: 58dB
Gain Channel B: 75dB
Channel A: 68dB
Tone Control Range Channel B: Bass: 12dB range @60Hz
Mid: 10dB range @600Hz
Treble: 7dB range @4kHz
Channel A: Bass: 20dB range @70Hz
Treble: 16dB range @2kHz
Line Out Level 375mV RMS @ full power output
Tube Types Preamp: (4) 12AX7 Power Amp: (4) EL84/6BQ5
Power Requirements 120VAC, 60Hz, 145VA/30W, 170VA/50W
100/115VAC, 50/60Hz, 145VA/30W, 170VA/50W
230VAC, 50/60Hz, 145VA/30W, 170VA/50W
Size and Weight 21.25”W x 11”H x 11.25”D, 35 lbs
©2001 SLM ELECTRONICS • A division of St. Louis Music • 1400 Ferguson Avenue • St. Louis, Mo 63133
P/N 47-547-13 • 05/01
TECHNICAL SPECIFICATIONS:
To keep this amplifier looking its best, avoid abrasive cleaners. Wipe the cabinet clean using a
slightly dampened cloth. Never use abrasive cleaners on the hardware since they could damage
their protective coatings.
Crate continually develops new products, as well as improves existing ones.
For this reason, the specifications and information in this publication
are subject to change without notice.
VC-50H Vintage Club Amplifier
www.crateamps.com
To Previous Page
Loading...
Need help?
Output
