Crathco D25 User Manual

ARMADO / DESARMADO DE DISPENSADOR DE BEBIDAS: MODELOS D25 Y D35
BEVERAGE DISPENSER ASSEMBLY / DISASSEMBLY: MODELS D25 AND D35
Place bearing sleeve on guide pin.
Coloca el casquillo sobre el pasador.
Turn bowl upside down
and place bowl gasket
over the neck of the bowl.
Voltea el tazón y coloca el
empaque sobre el cuello
del tazón.
Place the neck of the bowl
over center of the cooling
plate and with a back and
forth downward motion,
push bowl down into place.
Coloca el cuello del tazón
sobre el centro de la placa
de enfriamiento y con un
movimiento hacia adelante y
hacia atrás, empuje el tazón
hacia abajo en su lugar.
Place the pump cover over the guide pin.
Coloca la bomba sobre el pasador.
Place lockdown washer over
guide pin (hole A).
Coloca el seguro sobre el
pasador (orificio A).
Put mixing impeller over bearing sleeve with fin side up.
Acomoda el imán sobre el casquillo con las aletas hacia arriba.
Moisten bowl gasket
with water.
Humedece el empaque
con agua.
Lock
Lock
Pieces per bowl / Piezas por tazón
Bearing sleeve
Casquillo
Push Handle
Palanca
Valve
Válvula
Mixing impeller
Imán
Bowl gasket
Empaque
Bowl
Tazón
Pump cover
Bomba
Lockdown washer
Seguro
Lock
Lock
A B
A
PUSH
Grill
Rejilla
Drip tray
Charola escurridora
Bowl cover
Tapa del tazón
Assembly / Emsamblaje
1 2 3
5
4 6 7

Crathco D25 Specifications

General

Model	D25
Number of Bowls	2
Refrigerant	R134a
Frequency	60 Hz
Material	Stainless steel
Insulation	Foam
Temperature Range	35° - 41°F (1.7° - 5°C)

Summary

Beverage Dispenser Assembly D25/D35

Component Identification

Lists and illustrates all components required for assembly.

Assembly Steps 1-7

Covers the first seven steps of the assembly process.

Beverage Dispenser Assembly Continuation D25/D35

Assembly Steps 8-15

Continues the assembly process from step 8 through 15.

Model Variations D25 vs D35

Visual comparison and confirmation of Model D25 and D35.

Beverage Dispenser Disassembly, Cleaning & Cautions D25/D35

Disassembly Steps 1-7

Covers the seven steps for disassembling the beverage dispenser.

Cleaning Instructions

Guidelines for washing all parts after disassembly.

Safety and Usage Precautions

Important safety warnings and operational guidelines.

Beverage Dispenser Assembly CS-3L-16

Component Identification CS-3L-16

Lists and illustrates components for the CS-3L-16 model.

Assembly Steps 1-4

Covers the first four steps of the CS-3L-16 assembly process.

Beverage Dispenser Assembly & Disassembly CS-3L-16

Assembly Steps 5-10

Continues the assembly process for CS-3L-16 from step 5 through 10.

Disassembly Steps 1-6

Covers the six steps for disassembling the CS-3L-16 model.