®
8+
CREATE YOUR PAINT
SETUP
Line up each clip with a slot on the
base. Press clip down & snap into slot.
NOTE: Assembly is permanent. Do not
remove clips from base.
Hold paint tray slots above clips. Press
tray firmly to snap slots into clips.
Repeat with utility tray on the other
side. NOTE: Trays can be detached
& used separately.
Remove paint strips from pouch & place
in utility tray. Close lid to secure. Snap
brush into slot.
Remove cap & inner seal from base paint.
Replace with nozzle & press cap on tip.
Store paint pots in tray.
51 2 3 4
Choose a color to mix. The number of strips of each color
shown in the box will always add up to 5.
Place open paint pot into tray. Add base paint to fill line. NOTE: Each color square has 5 peelable mini-strips. Fold strip
on perforated line, then peel from backing. Push strips down
into base paint & cover completely.
31 2
Snap paint pot lid closed & align it on paint shaker with lid
tabs in “11 o’clock” position. Turn pot clockwise until tabs
snap into place at “12 o’clock” position.
Lefty or Righty! Turn crank quickly either way for up to a
minute. Stop to check color after 30 seconds. Mix more
if needed.
Label your paint color. Snap lid closed & store in tray.
Repeat steps 1 to 6 to make up to 15 more colors.
64 5
15 Each: Paint Pots, Labels
Color Mixing Guide
1 Bottle of Base Paint
10 Paper Sheets, 6"x9"
75 Paint Strips
1 Paintbrush1 Detachable Handle
4 Base Clips
1 Detachable Paint Pot Tray1 Detachable Utility Tray
CONTENTS
Paint Pot Slot
Base Paint
Bottle Slot
Paint Strip
Storage
Paintbrush Slot
Base
Crank
Mixer
• Protect all work surfaces & clothing. Paint strips & finished
paint may stain fabric and other household areas.
• Make sure hands are dry. Moist paint strips may stain
skin or wet surfaces.
• Fill paint pots with base paint to fill line.
Avoid overfilling.
• Follow color guide carefully: Use a total of 5 small strips
for any color you mix.
• Turning the crank faster will mix paint more quickly.
• Securely cap base paint bottle & paint pots after use
and during storage.
• Make sure all pieces are snapped into place
before transporting.
• If paint colors were stored, shake paint pots
before re-using.
FOR BEST RESULTS:
Wash brush with warm water & soap. Rinse & blot dry.
Store in utility tray.
Wipe off base & trays with a damp paper towel.
Make sure paint strips stay dry.
To store Paint Maker & contents:
• Secure base paint bottle cap & store behind the paint shaker.
• Snap all paint pot lids closed & place in tray.
• Close lid to secure paint strips.
• Stand labels, color guide & unused paper in clips between
base & trays.
• To carry paint maker, raise both trays to upright (vertical)
position, then snap handle onto clip at top of each tray.
1
2
3
CLEANUP & STORE