Unfold base & drop support legs to raise
the back panel.
Pull eyepiece panel to upright position
&
CLICK into place.
Firmly pull BOTH LENSES away from
the lens holder & snap into position shown.
Firmly pull the top lens up until it snaps
into position shown.
Set It Up!
1 2
3
4
Now you’re ready
to DRAW!
5
CLICK
FLIP
PULL
SNAP
Try copying from a printed scene, photo or
digital tablet image placed on back panel shelf.
(top lens should be in DOWN position)
Pull down yellow shelf for small objects
up to 3 inches high. (top lens should be in
UP position)
Fold legs under & lay back panel flat for
larger objects up to 6 inches high. (top lens
should be in UP position)
Place a sheet of white paper on base. Insert
corners under tabs to hold it in place.
Hold a pencil & place your hand on paper.
LOOK STRAIGHT AHEAD
through the eyepiece with one eye.
Once you can see your hand, pencil & object
through the eyepiece, you can start tracing.
If you need to stop & start again later, keep
art/object & paper position the same.
Moving either will put the image in a
different place on the paper.
To use the base for coloring your artwork:
pull the tab on the base, push the buttons on
the panel & slide panel out of the base.
What Do You Want To Draw?
Now Draw it!
OR
Pick
one
...
OR
Flat Art Small Objects Large Objects
For Best Results
• Use Sketch Wizard unit on a flat
surface in a brightly lit room.
• Use care near eyepiece &
panel. Slight bumps may knock
photos or 3D objects off of
yellow shelf.
• Use adhesive tape or mounting
putty (not included) to hold
photos, printed scenes, 3-D
objects in place if base moves.
• If you need to stop & start again
later, keep art/object & paper
position the same. Moving either
will put the image in a different
place on the paper.
• Store pencils in the space
behind the yellow shelf to keep
them handy & organized.
8
+
1 2
Visit
Crayola.com
to see cool
demo videos!
Tips
To Next Page
Need help?
General
