If the point cloud is desired, click Complete icon or , then click "Yes" button in the popup to
complete scanning. After this, users will enter the Process page to further process the data.
Optimize Point Cloud
The next step is to optimize the scanned 3D point clouds to obtain a better point cloud model. There are two
ways to achieve this function. In the automatic mode, the default parameters are used for point cloud fusion
optimization. In the manual mode, you can configure the desired resolution of the point cloud (i.e. point
pitch). The smaller the dot pitch, the better the detail of the 3D model.
To Next Page
Loading...
Need help?
General
