Icon : Exclude the point cloud on a flat base during scanning.
Icon : Stop the current scanning project and processing the point clouds on the
Process UI.
⑤ Prompt: Display some prompts during scanning.
⑥ Function Buttons:
Icon / : Start / pause scanning.
Icon : Stop the current scanning project and processing the point clouds on the
Process UI.
Icon : Deleting all the point clouds which have been stored.
Icon : Deleting the entire project to start over from device UI.
⑦ Status Bar: Display the device connection and project settings.
Adjust the brightness in Depth Camera
Adjust the Sun Icon on the smaller display. If available, try Auto first, but switch back to Manual before
capturing data to prevent lockups.
Under-exposure Perfect Over-exposure
Start or Pause Scanning
Click to Start/Pause scan. During scanning, please make sure the point cloud in the Depth Camera
window is adequate and the distance bar remains "Perfect". Move the scanner slowly and deliberately during
scanning while keeping a relatively fixed distance.
After clicking Pause, it is possible to resume scanning (say, after repositioning either the scanner or the
object being scanned).
Exclude Flat Base
Click icon to exclude the flat base which may bring bad influence during scanning . This function is
highly recommended when you scan a small target on the table.
Complete Scanning
Click to display the quality map. You should scan your traget adequately until the whole quality map
To Next Page
Loading...
