1.3 Enter printing interface, the printer starts to print, and the screen
will display printing information such as estimated time.
1.4 Parameters can be adjusted during the printing process, the
specific parameters are shown in the figure.
1.6 During the printing process, you can choose to Pause/Stop printing.
It can resume after pause, but it will exit the printing interface and go
back to Home page if you stop printing.
Note: Parameter adjustment can only
be performed after the printer starts
printing, and cannot be adjusted
during the preparation process (such
as heating).
1.5 Click to enter the motion parameter interface, you can adjust the
upper limit of the motion parameters (actual speed please refer to the
slice parameter setting).
09
To Next Page
Loading...
General