11. Slicing software displays previews and thumbnails
1. Ultimaker Cura 5.1.0
1.1 Add thumbnails on Ultimaker Cura 5.1.0, select "Extensions" - "Post
Processing" - "Modify G-code".
1.2 After entering, select the post-processing script shown in the figure
(‘’Add a script’’-’’Create Thumbnail), and a red dot will appear in the
post-script prompt box next to the slice button.
1.3 After the slicing is completed, export it in ufp format and upload it
using a U disk or WEB terminal. The Sonic Screen will automatically
produce a sliced G-code file with a preview image.
22
To Next Page
Loading...