8
ENGLISH
INSTRUCTIONS FOR USE
CONTROL PANEL
1. Hot foam button
2. Cold foam button
3. Milk heating button
4. Hot chocolate button
5. On/Off button
1. Fit the non-stick jug to the power base. Connect it to the power supply and make
sure that the magnetic attachments are properly positioned.
2. Pour the milk into the milk frother. Note that the amount of milk poured in must
not exceed the mark (see maximum capacity).
3. Connect the main body with milk to the power base and hear the sound of
“BIP”. The four functional indicator lights will all be on for 1 second and then
turn off in the non-operation condition. It goes into the standby state, indicat-
ing that the power is on.
4. Choose the function mode you want. After the set time has elapsed for the
mode you choose, the frother will stop and the frother will go into standby
mode.
5. Cancel the selection. If you need to cancel the selection, you can press the
button
once while the skimmer is running.
6. After canceling the selection the lights will turn on. At this time, you can se-
lect any function button to continue using the frother. If you do not select any
button for 10 seconds, the frother will automatically enter the standby state.
PARTS LIST
1. Lid
2. Non-stick jug
3. Maximum milk heating level
4. Maximum milk frothing level
5. Minimum milk level
6. Power base
7. Touch control panel
8. Magnetic drive part
9. Handle
10. Foamer spring
11. Magnetic accessory holder
MAX
MAX
MI N
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...
