Create WIND CALM - Please Remember; App Connection; How to Connect to the App

15
ENGLISH
The CREATE application is available for Android and iOS (look for the app on Google Play
or App Store or scan the QR code below). Depending on the provider, there may be costs
involved in downloading the app.
This appliance allows you to operate the appliance via your home network. A prerequisite is a
permanent 2.4Gh WiFi connection to your router and the free CREATE app. (Current internet
providers offer both 5Gh and 2.4Gh simoultaneously.)
We recommend disconnecting the appliance from the power supply when you are away from
home to prevent unintentional switching on while you are away.
APP CONECTION
PLEASE REMEMBER:
1. If the remote control is not working, please check the batteries are in the correct position
and fully charged.
2. If the remote control is not working, please whether there are any similar remote con-
trolled products nearby and running, because remote controls using the same frequency
will interfere with each other's signals.
3. If the battery is low this will affect the sensitivity of the transmitter and weaken signal
reception (the indicator light will ash to warn when the battery is low). Batteries must be
replaced if low,
4. Please remove the battery from the remote control if it will not be used for a long time.
5. For the maximum electricity voltage, see the above ”POWER PARAMETER LIST”
Please connect the ground wire correctly, otherwise it may cause the lights to dim or icker.
6. When installing the fan, make sure the fan ceiling cover does not place any pressure on
the antenna (or other wire), which may damage the wire and cause a short circuit.
OS iPhone OS Android
HOW TO CONNECT TO THE APP
1. Install the CREATE app and create a user account.
2. Set up a login password and log in the app.
3. Click on “Add device” (+) and then on the category corresponding to the ceiling fan.
4. On the remote control, press and hold the 1H and 4H buttons for 5 seconds (more or less) until
you hear a beep sound.
5. After that, click on “Conrm”.
6. Enter your WiFi network password and conrm.
7. While connecting, make sure your router, mobile phone and device are as close as possi-
ble. After that, your ceiling fan will be successfully paired to your CREATE app.
WIND CALM
WITHOUT LED LIGHT