Creative SoundBlaster Live! 5.1 - Connectivity

General Specifications 26
@ /
❑
Software record and playback control of Master, Digitized Voice, and inputs from MIDI device, CD
Audio, Line, Microphone, Auxiliary, TAD, SPDIF, Wave/DirectSound device, and CD Digital (CD
SPDIF)
❑
Separate bass and treble control
❑
Front and rear balance control
❑
Muting and balance control for individual playback sources
 -! 6789
!
❑
Decodes Doby Digital (AC-3) to 5.1 channels or pass-through compressed Dolby Digital (AC-3) PCM
SPDIF stream to external decoder
❑
Bass Redirection: Enhances bass ouput to subwoofer
 "+2
"

6""

9
❑
Multi-speaker technology
❑
Professional-quality panning and mixing algorithm
❑
Independent multiple sounds can be moved and placed around a listener

+
❑
Line-level analog Line input via stereo jack on rear bracket
❑
Mono Microphone analog input via stereo jack on rear bracket
❑
CD_IN line-level analog input via 4-pin Molex connector on card
❑
AUX_IN line-level analog input via 4-pin Molex connector on card
❑
TAD line-level analog input via 4-pin Molex connector on card
❑
CD_SPDIF digital input via 2-pin Molex connector on card, accepting sampling rates of 32, 44.1, and 48 kHz
4+
❑
ANALOG/DIGITAL OUT (front and rear SPDIF digital outputs) via 4-pole 3.5 mm minijack on rear
bracket
❑
Three line-level analog outputs via stereo jacks on rear bracket, Front and Rear Line-Outs
❑
Stereo headphone (32-ohm load) support on Front Line-Out
)
❑
D-Sub MIDI interface for connection to external for connection to external MIDI devices. Doubles
as Joystick port.
❑
AUD_EXT 2x20 pin header for connection to Optical Digital I/O card or Live! Drive