Creative ZiiSound D3x - Speaker Linking and System Configuration; Adding a Subwoofer for 1.1 Speaker System

7
1.3
Switching between paired devices
Enjoyyourfavouritemusicfromanotherpaired Bluetooth device by following these steps to establish
the connection.
Action LED status Status
_
Press“CONNECTButton”once
_
CONNECTLEDblinksand
stays lit
Ensurethatthenext
previously paired device has
Bluetooth powered on and
ready to accept connection
Bluetooth connection
switches.Readytostream
music.
2.1
Adding a subwoofer to the D3x to form a 1.1 speaker system
Section 2 : Linking with another ZiiSound D3x or DSx Wireless subwoofer
Note: Itisneccessarytoclearthememoryoflinkedspeakers(allD3x(s)andDSx)shouldyou
requiretocongureanewsetup.(Forexample,addinganotherD3xorDSx)
ProceedtoStep(B)ifyourD3xorDSxhavenotbeenlinkedwithotherspeakerbefore.
Ifyour D3x or DSx have beenlinkedbefore,followtheinstructionbelowtoclearlinksystem
memorytorecongureanewspeakersetup.
For the D3x(s)
Ensurethespeakerisinstandbymode.PressandholdthePowerON/Standbybuttonlocatedat
therearofthespeakeruntilLINKandCONNECTLEDblinks2timesandgoesoff.TheD3xLink
memory has been cleared.
For the DSx
PressandholdtheLINKButtonlocatedattherearofthesubwooferfor10secondsuntiltheLink
LEDblinks2timesandgoesoff.TheDSxLinkmemoryhasbeencleared.
A