INSTRUCTION
MANUAL
10
Installing your Freestanding Cooker
Bringing it all together
Installation requirements
THIS COOKER MUST BE INSTALLED BY A QUALIFIED INSTALLER IN ACCORDANCE WITH LOCAL
REGULATIONS
IMPORTANT: CONTACT AN AUTHORISED SERVICE AGENT FOR INSTALLATION OF YOUR OVEN!
First Use
IMPORTANT: When using your oven for the first time your cooker may give off an unusual odour from the heating
elements and insulation materials. This is normal for new cookers. To eliminate this odour run the oven at 250
degrees for 40-60 mins with the oven empty.
Unpacking
Carefully unpack and examine the appliance for any damage. If you think there is a defect, do not use the appliance
and contact Product Support on 01759 487836.
Positioning
1.
Make sure that there are no combustible or flammable materials,
such as curtains, in the vicinity of the installation.
2.
Furniture and cabinets surrounding the cooker must be of material
resistant to temperatures greater than 50°C.
3.
Surrounding furniture, cabinets and extractor fans should be
positioned in accordance with the diagram shown in the figure
4.
There must be at least 2cm of free space between the back wall
and the rear of the appliance to allow for ventilation and air
circulation.
5.
If fitted, the extractor fan must be at least 65cm above the
hotplates. If no fan is fitted the minimum distance between the
hotplates and any cabinet or other structure must be 75cm.
To Next Page
Loading...
