CHANGING COLORED PROTECTED COVER
The DIGI console is covered by a silicone shell that gives the product
its special look while also protecting it from accidental blows. Users
or an authorized center can replace the shell by following these
steps:
• Disconnect the device from the first stage/regulator group.
• Separate the shell from the body of the instrument, beginning
with the point shown.
• Pull gently outward, undocking the cover from the four perimeter
anchor points.
• At this point, slide the cover to be replaced over the hose.
• Slide on the new cover, taking care to insert all the stops in their
respective grooves.
• Reconnect the instrument as explained in the chapter:
“HOW TO CONNECT THE DIGI CONSOLE”.
E1124L1155-Manuale DIGI - 21_ENG.indd 31E1124L1155-Manuale DIGI - 21_ENG.indd 31 30/07/21 13:5330/07/21 13:53
31
EN
P124-20210630A
To Next Page
Loading...
