WARNING! Do not dive if the DIGI console display shows any
unexpected values, and contact a Cressi support center.
WARNING! Cressi Sub S.p.A. strongly recommends ending
the dive with air reserves of at least 50 BAR. This amount of air is
provided only for any unplanned emergencies. Below 50 BAR, the
value indicated will flash.
WARNING! Cressi Sub S.p.A. strongly recommends that you
consult the data provided by the DIGI console frequently during
your dive. Conditions such as temperature, any physical exertion
greater than a standard dive, or dives when under significant
emotional stress can significantly vary air consumption, and divers
can only prevent potential problems by carefully and frequently
checking this information.
LAUNCH SEQUENCE AFTER ACTIVATION
Immediately after it is activated, the DIGI console will run the launch
sequence, during which it will display, in order:
1. Launch sequence
2. Version of FIRMWARE INSTALLED
3. Display of current data
The DIGI console activates automatically when the SCUBA unit is
pressurized. Tank pressure must be greater than 10 BAR.
E1124L1155-Manuale DIGI - 21_ENG.indd 24E1124L1155-Manuale DIGI - 21_ENG.indd 24 30/07/21 13:5330/07/21 13:53
24
EN
P124-20210630A
To Next Page
Loading...
