The Crestron® Avia® DSP-860, DSP-1280, DSP-1281, DSP-1282, and
DSP-1283 digital signal processors are functionally similar with varying
capabilities. For simplicity within this guide, the term "DSP" is used except
where noted.
In the Box
1 DSP-860, DSP-1280, DSP-1281, DSP-1282, or DSP-1283,
Crestron Avia Digital Signal Processor
Additional Items
2 Bracket, Rack Ear, 1U (2032122)
1 Cable, Power, 6 ft 7 in. (2 m) (2001134)
DSP-860 Only
14 Connector, 3-Pin (2003575)
DSP-1280, DSP-1281, DSP-1282, and DSP-1283 Only
20 Connector, 3-Pin (2003575)
Install the DSP
The DSP occupies 1U of rack space. Use the three screws from the front
part of each side panel, and a #1 or #2 Phillips screwdriver to attach the
two included rack ears to the device, as shown in the following illustration.
Then mount the device into the rack using four mounting screws (not
included).
1
DSP-860, DSP-1280, DSP-1281, DSP-1282, & DSP-1283
QuickStart
Crestron Avia® Digital Signal Processors
To Next Page
Need help?
General
