Crestron Avia DSP-860 - User Manual

The Crestron® Avia® DSP-860, DSP-1280, DSP-1281, DSP-1282, and
DSP-1283 digital signal processors are functionally similar with varying
capabilities. For simplicity within this guide, the term "DSP" is used except
where noted.
In the Box
1 DSP-860, DSP-1280, DSP-1281, DSP-1282, or DSP-1283,
Crestron Avia Digital Signal Processor
Additional Items
2 Bracket, Rack Ear, 1U (2032122)
1 Cable, Power, 6 ft 7 in. (2 m) (2001134)
DSP-860 Only
14 Connector, 3-Pin (2003575)
DSP-1280, DSP-1281, DSP-1282, and DSP-1283 Only
20 Connector, 3-Pin (2003575)
Install the DSP
The DSP occupies 1U of rack space. Use the three screws from the front
part of each side panel, and a #1 or #2 Phillips screwdriver to attach the
two included rack ears to the device, as shown in the following illustration.
Then mount the device into the rack using four mounting screws (not
included).
1
DSP-860, DSP-1280, DSP-1281, DSP-1282, & DSP-1283
QuickStart
Crestron Avia® Digital Signal Processors

Crestron Avia DSP-860 Specifications

General

Sampling Rate	48 kHz
Power Supply	100-240V AC, 50/60 Hz
A/D Converters	24-bit
D/A Converters	24-bit
Dynamic Range	>110 dB
Ethernet Ports	1
RS-232 Ports	1
GPIO Ports	8
Audio Inputs	8 balanced mic/line inputs
Processing Power	32-bit floating point DSP
Network Connectivity	10/100 Mbps Ethernet
Control Interfaces	Ethernet, RS-232
Frequency Response	20 Hz to 20 kHz (+/- 0.5 dB)
THD+N	<0.005%
Operating Temperature	0°C to 40°C
Mounting	1U rack mount
USB Ports	1
Dimensions	482.6 mm (19 in) W x 44.5 mm (1.75 in) H x 254 mm (10 in) D
Audio Outputs	6 balanced line outputs
Input Impedance	Balanced: 20 kΩ, Unbalanced: 10 kΩ