Download the Crestron Avia Audio
Tool
DSPs use the Crestron Avia Audio tool for configuration and operation.
Download the Crestron Avia Audio tool from
www.crestron.com/software.
Configure the DSP
Once the DSP is connected to the same subnet as the host PC running
the Crestron Avia Audio tool, start the tool and do the following:
1. Click Add New Network DSP in the workspace on the left side of the
window.
2. Click Ethernet to launch the Device Discovery function. A list of units
found on the subnet is displayed.
NOTE: If a DSP is not listed, verify that all connections have been made
and that all devices and the computer running the Crestron Avia Audio
tool are on the same subnet.
8
DSP-860, DSP-1280, DSP-1281, DSP-1282, & DSP-1283
QuickStart
Crestron Avia® Digital Signal Processors
To Next Page
Loading...
Need help?
General
