Crestron D3 Pro
™
Software
If the device is a Cresnet device the Network ID is referred to as a Cresnet ID, or Net
ID.
If the interface is an Ethernet touchpanel, such as the TPS-5000 or TPS-6000 with
TPS-ENET card, then the Network ID is referred to as an IP ID. In addition to the IP
ID, you should enter the IP address of the Ethernet touchpanel.
With wireless interfaces, such as the MT-500C, the Network ID is an RF ID. Here
the RF ID identifies the wireless receiver, such as the CNRFGWA.
Reference Guide – DOC. 5998a Crestron D3 Pro™• 15
To Next Page
Loading...