Crestron DM-RMC-4KZ-SCALER-C - Upgrade the Firmware; Determine the IP Address

The AUDIO OUT connector uses a 5-pin terminal block for balanced or
unbalanced analog audio output.
Refer to the following table and diagrams for analog audio output pin
assignments and connection information.
Signal Name Balanced Audio Output Unbalanced Audio Output
+ L+ L+ Out
− L− Open
G Shield/ground Common ground
+ R+ R+ Out
− R− Open
Upgrade the Firmware
Before using the device, upgrade the firmware. The latest firmware can be
downloaded from the DM-RMC-4KZ-SCALER-C product page on the
Crestron website (www.crestron.com).
Determine the IP Address
The physical configuration of the DM-RMC-4KZ-SCALER-C within a
DigitalMedia 8G+ system determines how the IP address of the receiver
isset:
l If the DM-RMC-4KZ-SCALER-C is connected to a DigitalMedia
switcher, the IP address is configured by the switcher automatically.
You do not need to set the IP address.
l If the DM-RMC-4KZ-SCALER-C is connected directly to a DigitalMedia
8G+ transmitter (commonly referred to as a standalone configuration
in which no DigitalMedia switcher is used), the IP address of the
receiver is assigned using DHCP (Dynamic Host Configuration
Protocol) by default. If you wish to assign a static IP address, do either
of the following:
o
To assign the default static IP address of the receiver, hold down
the SETUP button while the unit boots up. The default static IP
address, which is 192.168.1.253, overwrites the current setting.
o
To manually set a static IP address other than the default address,
use the Crestron Toolbox™ software.
4
DM-RMC-4KZ-SCALER-C
QuickStart
DigitalMedia 8G+® 4K60 4:4:4 HDR Receiver and Room Controller with Scaler