Crestron HD Streaming Receiver and Room Controller 100 - Page 14

10
•
DM-RMC-100-STR: HD Streaming Receiver Supplemental Guide – DOC. 7846A
Stream Configuration Guidelines (Continued)
CONFIGURATION
ITEM GUIDELINES
Output Options,
Volume
The
Volume
button toggles audio on and off. By default, the
Volume
button is enabled, showing three sound waves emanating from the
speaker icon ( ). Audio is not muted.
To disable the
Volume
button, deselect the button. The three waves
emanating from the speaker icon are removed ( ) and audio is muted.
To adjust the volume, drag the
Volume
slider to the left or to the right.
The volume decreases in one-tenth decrements when the slider is
dragged to the left and increases in one-tenth increments when the
slider is dragged to the right. Values range from
-80
to
20
decibels.
The default setting is
0
.
Output Options,
Bass
Adjusts the bass level of the audio. The bass level decreases in
one-tenth decrements when the slider is dragged to the left and
increases in one-tenth increments when the slider is dragged to the
right. Values range from
-10
to
10
decibels. The default setting is
0
.
Output Options,
Treble
Adjusts the treble level of the audio. The treble level decreases in
one-tenth decrements when the slider is dragged to the left and
increases in one-tenth increments when the slider is dragged to the
right. Values range from
-10
to
10
decibels. The default setting is
0
.
Output Options,
Delay
Specifies the audio delay so that the audio is in sync with the video.
To adjust the delay, use the
Delay
slider or the
Delay
spin box:
• To use the
Delay
slider, drag the slider to the left or to the right.
The delay decreases when the slider is dragged to the left and
increases when the slider is dragged to the right. Values range
from
0
to
100
milliseconds. The default setting is
0
.
The value set by the
Delay
slider appears in the
Delay
spin box.
• To use the
Delay
spin box, select the desired value. Valid
values range from
0
to
100
milliseconds.
The value entered in the
Delay
spin box adjusts the
Delay
slider
to the corresponding value.
3. Use the transport buttons to control streaming as appropriate:
• Begin streaming by selecting the
Start
button ( ). The button starts
blinking green every 500 milliseconds while the DM-RMC-100-STR sets up
the stream. When the stream starts, the button becomes solid green.
In addition, the
Status
field (read only) indicates that the stream started.
• Pause streaming by selecting the
Pause
button ( ). The button starts
blinking yellow every 500 milliseconds until the stream pauses. When the
stream pauses, the button becomes solid yellow. In addition, the
Status
field (read only) indicates that the stream paused.
• Stop streaming by selecting the
Stop
button ( ). The button starts
blinking red every 500 milliseconds until the stream stops. When the
stream stops, the button becomes solid red. In addition, the
Status
field
(read only) indicates that the stream stopped.