Crestron MC2E - Page 31

Crestron MC2E 2-Series Professional Media Controller
In Program Manager, the C2I-MC2-IR4 symbol contains no signals; to program an
IR device or serial driver, expand the C2I-MC2-IR4 card by clicking the plus sign in
Program View. Then drag the symbol to Detail View. (Alternatively, double-click
the symbol.)
Slot 3: C2I-MC2-IO4
The MC2E provides four I/O ports called Versiports, each of which can function as a
digital input, a digital output, or an analog input. Each Versiport has a corresponding
pullup resistor.
In Program Manager, drag the C2I-MC2-IO4 symbol from Program View to Detail
View.
Detail View of C2I-MC2-IO4 (slot 3) in SIMPL Windows’ Programming Manager
The symbol contains the following signals, arranged here according to mode:
Signals
Digital output mode
• 4 digitals: <o1> through <o4>
Digital input mode
• 4 digitals: <i1> through <i4>
Analog input mode
• 4 analogs: <i1> through <i4>
• For each analog, one corresponding minimum change value:
<MinChange1> through <MinChange4>
All Versiport modes
• For each Versiport, one corresponding pullup resistor: <pu-disable1>
through <pu-disable4>
Defining a signal puts the signal into the corresponding mode. For example, defining
the analog input <i1> configures that Versiport as an analog input. A Versiport can
only operate in one mode. That is, if you define <o1> you should not also define
<i1>.
Operations Guide – DOC. 6142 2-Series Professional Media Controller: MC2E • 27