Crestron RMC3 - DIN Rail Mounting

3-Series Room Media Controller Crestron RMC3
DIN Rail
Mounting
The RMC3 can be mounted onto a DIN rail.
To mount the RMC3 onto a DIN rail, perform the following steps (refer
to the illustration below):
1. Detach the RMC3 from the mounting bracket by pulling the left
and right flanges of the bracket outward to release the tabs that
hold the RMC3 in place.
2. Using a flat-head screwdriver, pull the DIN rail release tab
downward.
3. Position the DIN rail mounting tabs (located on the rear of the
bracket, not shown in the illustration) over the top edge of the DIN
rail, and then push the DIN rail release tab upward to lock the
mounting bracket onto the rail.
4. Align the slots on the bottom of the RMC3 with the RMC3
mounting tabs of the bracket, and then press the RMC3 into the
bracket until the RMC3 snaps into place.
5. (Optional) Secure the RMC3 in the mounting bracket by using
the two included #6-32 x 3/8” Phillips pan head screws and the
hole on the left and right sides of the assembly.
DIN Rail Mounting
Screws, Phillips Pan Head (2)
#6-32 x 3/8”
Right Flange
Left Flange
Mounting Bracket
DIN Rail
(Not Included)
DIN Rail
Release Tab
18  Room Media Controller: RMC3 Operations & Installation Guide – DOC. 7558B