Rechargeable Battery Pack Crestron ST-BTPN
Charging
NOTE: Typically, the battery pack is good for 500 charge/discharge
cycles.
To charge the ST-BTPN:
• Use the powered ST-DSN docking station with battery guide; or
• Install the ST-BTPN in a ST-1550C or 1700C and mount
touchpanel on a powered ST-DSN docking station.
CAUTION: Internal damage to battery pack may occur if it is mounted
by itself on the ST-DSN without the battery guide.
NOTE: The battery pack may take up to 6 hours to charge in a powered
touchpanel. Refer to Specifications on page 2 for charging information.
For further information, consult the ST-DSN Operations Guide (Doc.
6095). The latest version of the guide is available from the Downloads |
Product Manuals section of the Crestron website (www.crestron.com)
.
Installation
The unique design of the ST-BTPN prevents it from being installed
improperly. The rechargeable battery pack fits only one way in the
battery compartment of the touchpanel.
Although the ST-BTPN can be installed in several Crestron wireless
touchpanel models, the ST-1700C and STX-1700C are the most common
models to use the battery pack. These models have the same shape and
battery compartment location. Therefore, as an example, the illustration
on the next page shows the ST-BTPN properly seated in the ST-1700C.
Complete the steps on the next page to install the battery.
6 • Rechargeable Battery Pack: ST-BTPN Operations and Installation Guide - DOC. 6088
To Next Page
Loading...