quickstart guide
TSW-1052
www.crestron.com
888.273.7876 201.767.3400
Specifications subject to
change without notice.
TSW-1052
10.1” Touch Screen
The Crestron
®
TSW-1052 touch screen installs into a standard 2-gang or 3-gang U.S electrical box or a
2-gang European electrical box. It can also be attached directly to drywall and other surfaces over the
front of a 2 3/8” (60 mm) high by 3 3/8” (86 mm) wide cutout. When installed, it protrudes just 1/2”
(13 mm) from the mounting surface and magnetically adheres to its included mounting bracket.
It is supplied with screws for installation.
1
Install the Touch Screen
QUICKSTART DOC. 7576B (2040593, Sheet 1 of 2) 07.14
1
To mount the TSW-1052 into an electrical box, use the following procedure:
1. Use four of the eight included screws (four #06-32 x 3/4” or four 3 x 16 mm) to attach the mounting
bracket (2034503) to the electrical box, as shown in the following illustrations.
For U.S.-style installations, use the #06-32 x 3/4” screws (2033247).
For European-style installations, use the 3 x 16 mm screws (2013788).
Mount the TSW-1052 into a U.S. Electrical Box
2. Power and data connection to the TSW-1052 is provided by a single Ethernet cable connected to
the LAN port at the rear of the unit. A Crestron PoE power supply or PoE-capable network switch is
recommended. Apply power after the Ethernet cable is connected.
3. Carefully position the touch screen over the mounting bracket and gently place it in position.
The magnets on the rear of the touch screen hold it in place on the mounting bracket.
Hardware Connections for the TSW-1052
Mount the TSW-1052 into a European Electrical Box
For regulatory compliance information, refer to Doc. 7577.
NOTE: For U.S.-style installations, use a #2 Phillips screwdriver. For European-style installations,
use a #1 Phillips screwdriver or equivalent.
Mounting Bracket
(2034503)
Screws (4) #06-32 x 3/4”
(2033247)
TSW-1052
U.S. Electrical Box
Mounting Bracket
(2034503)
Screws (4) 3 x 16 mm
(2013788)
TSW-1052
European Electrical Box
Reset Button
LAN PoE:
10BASE-T/100BASE-TX
Ethernet to LAN
To Next Page
Need help?
General
