ZUMMESH-NETBRIDGE
Zūm™ Network Bridge
Installation Guide
Description
The Crestron
®
ZUMMESH NETBRIDGE enables Zūm device setup from a mobile app and
integrates a stand-alone Zūm lighting control system with the Zūm hub (sold separately)
for a centrally managed, enterprise-wide lighting control system. Attach the Network
Bridge to a Zūm J-box device (sold separately) to use the mobile app to set up the Zūm
devices in the room. Adding the Zūm hub to the centrally-managed lighting system
enables all of the network bridges to interface for centralized monitoring, management,
and control of the lighting systems throughout an entire building.
A basic single-room Zūm system consists of Zūm mesh devices, i.e., dimmers, switches,
keypads, and sensors. The Zūm mesh devices in the room communicate directly with each
other without the need for a centralized gateway or processor.
Additional Resources
Visit the product page on the Crestron website (www.crestron.com)
for additional information. Use a QR reader application on your
mobile device to scan the QR image.
Installation
WARNING: To avoid re, shock, or death, turn off the power at the circuit breaker or
fuse and test that the power is off before wiring!
NOTE: Install and use this product in accordance with appropriate electrical codes and
regulations.
NOTE: Ensure that the ZUMMESH-NETBRIDGE is installed within range of the
ZUMNET-GATEWAY.
Mount the ZUMMESH-NETBRIDGE to any J-box device.
1. Use a at-head screwdriver to remove the cover on the J-box device.
2. Align the ports on the ZUMMESH-NETBRIDGE and the J-box device, and then
insert the network bridge into the J-box device. The network bridge snaps into
place.
Neutral (white)
Hot (black)
100-277 Vac power
from breaker
Remove the network bridge.
1. Place your thumb on the side of the network bridge that is nearest the J-box.
2. Press the network bridge away from the J-box. While pressing on the side of the
network bridge, slightly lift your thumb up. The network bridge should easily detach
from the J-box device.
Using the Zūm App
The Zūm app is available for download from the App Store
®
app in iTunes
®
software. The
Zūm app provides quick and easy setup of a Zūm network.
SPECIFICATION DETAILS
Power Requirements
Average Draw 60 mA, 3.3 Volts
Peak Draw 250 mA, 3.3 Volts
Power provided via the ZUMMESH-JBOX or
ZUMMESH-JBOX-PSU (sold separately)
Enclosure
Housing Plastic, white
Mounting Mounts to a Zūm J-Box Zone Controller or a Zūm
Network Bridge Power Supply (sold separately);
Plenum rated for mounting in air-handling space
Environmental
Temperature 32° to 104 °F (0° to 40 °C)
Humidity 10% to 90% RH (noncondensing)
Dimensions
Height 1.66 in (42 mm)
Width 1.94 in (49 mm)
Depth 0.76 in (20 mm)
Weight 3 oz (85 g)
To Next Page
Need help?
General
